Anker PowerPort Atom PD 2 User Manual

Product Overview

Anker PowerPort Atom PD 2 User Manual

Model: A2029

Using Your Product

The product features two USB-C ports, labeled 1 and 2.

Illustration showing two USB-C cables connected to the Anker PowerPort Atom PD 2, one in each port.

For the fastest and safest charge, use an Anker® cable, your device's original cable, or another certified cable (such as MFi).

Additional Safety Instructions

• Prevent water or moisture ingress.
• Keep the product away from extreme temperatures, direct sunlight, hot ovens, or open flames.
• Prevent objects from falling or liquids (including any acids) from splashing onto the charger.
• Connect only to an outlet providing the voltage level marked on the charger.
• To reduce the risk of damage to the power cord, do not disconnect the charger from the outlet by pulling the cord. Always hold the charger and pull it from the outlet.
• Ensure the power cord is routed so there is no danger of it being stepped on or tripped over.
• Warning: Never replace the fuse or plug with non-original replacements.
• Improper connection may cause electric shock to the user.
• When using an extension cord, ensure the grounding conductor in the cord is intact.
• For indoor use only. Do not use in places exposed to sun, rain, or excessive moisture.
• The power plug serves as the primary means of disconnecting the device from the power supply and must be readily operable.
• Ensure the power plug is connected to a grounded outlet to prevent electric shock or injury.
• Maintain the disconnecting device (power plug and socket) in a ready-to-use operational state.
• Warning: Do not expose batteries to high heat such as sunlight or fire.
• Do not disassemble, open, drop, or cause any other damage to the product.
• Keep away from high-voltage equipment.
• Keep away from children.

Specifications

Input

100-240 V ~ 1.7 A 50-60 Hz

Output (Single Port Loading)

(Max Per Port)

Output (Both Ports Loading Simultaneously)

(Max Per Port)

Average active efficiency: 82.2%

Efficiency at low load (10%): 64.8%

No-load power consumption: 0.13 W

Size: 68 x 69 x 28 mm / 2.7 x 2.7 x 1.1 in

Weight: 178 g / 6.3 oz

Customer Service

Warranty

18-month limited warranty*

*Please note that your rights under applicable law governing the sale of consumer goods remain unaffected by the warranties given in this Limited Warranty.

Technical Support

Lifetime technical support

Contact Information

• Email: support@anker.com
• USA: +1 (800) 988 7973 (Mon - Fri 9:00am - 5:00pm PT)
• UK: +44 (0) 1604 936200 (Mon - Fri 6:00 - 11:00 GMT)
• Germany: +49 (0) 69 9579 7960 (Mon - Fri 6:00 - 11:00 CET)
• Japan: +81 0344557823 (Mon - Fri 9:00 - 17:00 JST)
• China: +86 4000550036 (Mon - Fri 9:00 - 17:30 CST)

Compliance & Importer Information

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1) Reorient or relocate the receiving antenna. (2) Increase the separation between the equipment and receiver. (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. (4) Consult the dealer or an experienced radio / TV technician for help. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

IC Statement

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

This digital apparatus complies with CAN ICES-3(B)/NMB-3(B).

Declaration of Conformity

Hereby, Anker Innovations Limited declares that the product type A2029 is in compliance with Directive 2014/35/EU & 2014/30/EU & 2011/65/EU & 2009/125/EC. The full text of the EU declaration of conformity is available at the following internet address: https://www.anker.com

Anker Innovations Limited | Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong Kong

This product is suitable for use at altitudes up to 2000m and in non-tropical regions.

Importer Information (for FCC matters)

Company Name: Fantasia Trading LLC

Address: 5350 Ontario Mills Pkwy, Suite 100, Ontario, CA 91764

Telephone: +1 800 988 7973