Electrolux WELL Q6/Q7/Q7-P Cordless Vacuum Cleaner Instruction Manual
Product Identification
This document serves as the instruction manual for the Electrolux WELL Q6, Q7, and Q7-P series of cordless vacuum cleaners.
Brand: Electrolux
Models Covered:
- WELL Q6: ADS-13G-22 25013GPG
- WELL Q7/Q7-P: KSC-18W-350050HE
Included Accessories
Your vacuum cleaner may come with a variety of accessories. The specific accessories included can differ between models.
Common accessories include:
- Floor nozzle for general floor cleaning.
- Crevice tool for tight spaces.
- Small brush for upholstery or delicate surfaces.
- Other specialized brushes or nozzles.
- Charging stand or adapter.
- Filters.
Assembly and Setup
Follow these steps to assemble your Electrolux vacuum cleaner.
Charging the Battery
Ensure the battery is fully charged before first use. To charge:
- Connect the charger to the vacuum cleaner unit or the battery pack.
- The charging process takes approximately 4.5 hours for a full charge.
- LED indicators on the unit or battery will display the charging status and remaining battery level.
Assembling the Vacuum Cleaner
The diagrams illustrate the assembly process:
- Step 1: Attach the main vacuum cleaner body to the cleaning wand. This is typically done by inserting one into the other until they click into place.
- Step 2: Connect the floor nozzle to the bottom of the cleaning wand.
- Handheld Use: The main unit can often be detached from the wand to be used as a handheld vacuum cleaner.
- Alternative Configuration: In some cases, the floor nozzle can be attached directly to the handheld unit for specific cleaning tasks.
Operating the Vacuum Cleaner
Learn how to use your Electrolux vacuum cleaner effectively.
Power Control
Use the power switch [power switch] located on the main unit to turn the vacuum cleaner ON and OFF.
Battery Level Indicators
The battery status is shown via LED indicators:
- 100%: Battery is fully charged.
- 75-100%: Battery is charged.
- 50-75%: Battery is partially charged.
- 25-50%: Battery is low.
- 0-25%: Battery is very low and requires charging.
Maintenance and Care
Proper maintenance will keep your vacuum cleaner performing optimally.
Emptying the Dustbin
To empty the dustbin:
- Release the dustbin from the main unit by pressing the release button [release button].
- Open the dustbin lid to dispose of the collected dirt and debris.
Cleaning Filters
Regularly clean the filters for consistent suction power. Filters should be cleaned according to the following guidelines:
- Access the filter(s) by removing the designated cover.
- Clean the filters, typically by rinsing them under running water.
- Ensure filters are completely dry before reinserting them. Allow at least 24 hours for drying.
- Some components may have a maximum operating temperature of 40°C.
- Filter cleaning frequency may be recommended monthly (1M) or bi-monthly (2M).
Important Information
Battery Pack Installation: Handle the battery pack installation with extreme care. Replacement battery packs must be sourced from Electrolux or an authorized service center.