MARQUANT 005044, 005045 Bathroom Scales

Safety Instructions

Symbols

• ? Read the instructions.
• ✅ Approved in accordance with relevant directives and regulations.
• ♻️ Recycle discarded product in accordance with local regulations.

Technical Data

Use

Note:

• Keep the glass plate dry; a wet plate presents a slipping hazard.
• Stand still while weighing; the display changes if your body weight shifts.
• Avoid dropping the product and do not subject it to knocks or blows – risk of material damage.
• This product is a precision instrument and must be handled carefully.
• If the product does not start, check that the battery is inserted and not discharged. Insert a charged battery.
• If the display shows an error or the product does not switch off automatically, remove the battery, wait 3 seconds, and reinsert it to reset the software.

Placement and Operation

1. Place the bathroom scales on a hard, level surface for best precision. Do not place it on a carpet or other soft surface. [Diagram: Scale on flat surface]
2. Note: Check before weighing that there are no foreign objects under the product.
3. Carefully step onto the bathroom scales. The scales start automatically. [Diagram: Person stepping on scale]
4. Stand still, spreading your weight uniformly, until the display stabilises. [Diagram: Stable weight reading]

Automatic Power-Off

After stepping off the scales, they switch off automatically. They also switch off if the measured weight does not change within approximately 8 seconds. [Diagram: Scale display after auto-off]

Battery Replacement

Remove the insulation from the battery before use. [Diagram: Battery insulation removal]

1. Remove the battery cover and lift it off. [Diagram: Battery cover removal]
2. Press the battery lightly to spring it up. [Diagram: Battery pushed up]
3. Put the positive terminal of the new battery under the positive symbol and press the battery in place. Double-check that the battery is inserted with the correct polarity. [Diagram: New battery insertion]

Maintenance

• Clean the bathroom scales with a damp cloth. Make sure that no water gets into the scales.
• Do not use strong or abrasive detergents.
• Store the bathroom scales in a dry and cool place.
• When putting the bathroom scales away, keep them flat.

Troubleshooting

Overload Reading

Overload (maximum permissible weight shown on the display). [Diagram: Overload indicator]

Step off to avoid damaging the scales.

Battery Indicator

Discharged battery. Put in a new battery. [Diagram: Low battery indicator]

Repeat Weighing

'C' is shown after stepping off if there was an error during the weighing. Repeat the weighing. [Diagram: Repeat weighing prompt]