MARQUANT 004854 Wall Mount Bracket

Safety Instructions

WARNING!

• ⚠️ Do not exceed the maximum load capacity – risk of serious personal injury and/or material damage.
• Mount brackets must be attached as specified in the operating instructions. Improper installation may result in personal injury and/or material damage.
• Safety equipment and suitable tools must be used. This product should only be installed by qualified professionals.
• This product is designed for mounting on walls with wood studs, concrete walls, or brick walls.
• Ensure the wall can support the weight of the bracket and the equipment it will hold.
• Tighten screws properly, but not too tightly – risk of material damage.
• This product contains small parts that could be a choking hazard if swallowed. Keep these items away from children.
• This product is intended for indoor use only. Outdoor use may lead to personal injury and/or material damage.

IMPORTANT!

• Ensure you have all parts listed. Contact Jula's customer service if any parts are missing or damaged.
• Check at least every three months that the bracket is correctly mounted.

Technical Data

Assembly Instructions

Parts List

• Bracket A (x1)
• Bracket B (x1)
• Screws M-A (M4x14) (x4)
• Screws M-B (M5x14) (x4)
• Washers M-C (D5) (x4)
• Screws W-A (x3)
• Screws W-B (x3)
• Screws W-C (x3)

Step 1: Prepare Bracket

Diagram shows the main bracket components: Bracket A (x1) and Bracket B (x1). Also lists the included hardware: Screws M-A (M4x14) (x4), Screws M-B (M5x14) (x4), Washers M-C (D5) (x4), Screws W-A (x3), Screws W-B (x3), and Screws W-C (x3).

Step 2: Attach Bracket Components

Diagram shows Bracket B being attached to Bracket A using screws and a screwdriver. An arrow indicates the direction of assembly. The final image shows the assembled bracket unit.

Step 3: Prepare Wall Mounting

Diagram illustrates preparing the wall for mounting. It shows drilling holes with a specified diameter (Ø 4.5mm / Ø 3/16") and depth (55mm / 2.2 inches). It also shows the bracket being positioned on the wall, indicating the use of screws W-A and W-C for initial placement.

Step 4: Mount Bracket to Wall

Diagram shows the bracket being securely mounted to a wall. It depicts drilling holes, potentially using wall plugs (indicated by checkmarks ✔️ for correct use and crosses ❌ for incorrect use), and then fastening the bracket using screws W-B, W-C, and W-A. A spirit level is shown to ensure proper horizontal alignment (checkmarks ✔️ for correct, crosses ❌ for incorrect).

Step 5: Attach to TV/Screen

Diagram shows the bracket being attached to the back of a TV or screen. It specifies using screws M-A/M-B and washers M-C for this connection. Different attachment scenarios for TVs are indicated with checkmarks ✔️ and crosses ❌.

Step 6: Adjust and Finalize

Diagram illustrates two people (?‍?‍?) lifting and attaching the screen to the mounted bracket. It also shows the use of a screwdriver or Allen key (part B) to adjust the tilt angle of the bracket, which can be set between +3° and -12°.