Artika Alton LED Ceiling Light Fixture Installation Manual

Important Information

IMPORTANT: READ CAREFULLY AND KEEP.

WARNING: Risk of electrical shock. Turn off breaker at the panel. Switch off the main electrical supply from the fuse box/circuit breaker before installing the unit or doing any maintenance. Do not use outdoor.

CAUTION: If using a dimmer, it must be LED compatible.

IMPORTANT: The installer and/or user must read, understand and follow these instructions before installing the product. This product must be properly installed before it is used. If instructions are not followed, the manufacturer will not be held responsible for any problems or product malfunction. Failure to follow installation and/or operating instructions voids the warranty. We recommend that this product be installed by a certified electrician. In some states or provinces, it is a legal requirement for this type of product to be installed by a certified electrician, according to the electrical and building codes effective in the region where the unit is used.

Included Hardware

What You Will Need

• Screwdriver
• Pencil
• Drill

Installation Steps

Step 1: Mount the Bracket

Attach the mounting bracket to the ceiling using appropriate screws. Ensure wires from the ceiling are accessible through the bracket. Diagram Description: Shows a mounting bracket being attached to a ceiling surface, with electrical wires extending from the center.

Step 2: Attach Fixture Base

Align the fixture base (E) with the mounting bracket. Secure the base to the bracket using the provided retaining screws (C) and junction box screws (B). Diagram Description: Shows the fixture base being positioned over the mounting bracket and secured with screws.

Step 3: Connect Wires

Connect the wires from the fixture to the corresponding wires in the ceiling electrical box: White (N) to White (N), Black (L) to Black (L), and the Ground wire (GND) to the ground wire from the ceiling. Use the provided wire connectors (D) for secure connections. Diagram Description: Close-up view of wire connections: White wire to White wire, Black wire to Black wire, and Ground wire to Ground wire, using wire connectors.

Step 4: Secure Fixture

Ensure all wiring is safely tucked into the electrical box. Mount the fixture body onto the bracket and secure it. Diagram Description: Shows the fixture being attached to the ceiling, with wires connected.

Step 5: Prepare Mounting Points

If mounting directly to a surface without a junction box, drill holes using the appropriate drill bit. Insert wall anchors (A) into the drilled holes. Diagram Description: Shows a drill creating holes in a surface and wall anchors being inserted.

Step 6: Install Fixture

Attach the fixture to the prepared mounting points using the provided screws. Diagram Description: Shows the fixture being screwed into place on the ceiling.

Step 7: Install Diffuser and Set Tunable White

Align the diffuser (F) with the fixture and twist or snap it into place. The fixture features Tunable White technology, allowing adjustment of color temperature (e.g., 3000K Warm White, 4000K Cool White, 5000K Daylight). Adjust the color temperature as desired using the internal switch or mechanism. Diagram Description: Shows the diffuser being attached to the fixture. A close-up inset shows color temperature options (3000K, 4000K, 5000K) with arrows indicating selection.

Compliance Information

Canada (IC)

Operation is subject to the following two conditions: 1. This device does not cause interference, and 2. This device must accept any interference received, including interference that may cause undesired operation.

USA (FCC)

WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. 2. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

NOTE: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. If this equipment causes harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and the receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.

Warranty

Artika For Living Inc. offers a three-year (3) limited warranty on manufacturing defects from the date of purchase for residential use only. The warranty is extended to the original owner in the US, Canada, Mexico, the UK, Iceland, France and Spain and is non-transferable. It does not apply to retailers, commercial applications or establishments. The original sales receipt is required for all warranty claims. The remedy under this limited warranty shall be product or part replacement at Artika's discretion as provided herein and may not exceed the original purchase price.

This warranty is valid only on products installed in accordance with the building code and laws in effect in the region where the unit is being used, as well as in accordance with the provided instruction manual. It does not cover products installed incorrectly or subjected to abnormal use. Normal wear and tear, misuse, negligence, vandalism, improper maintenance, accident, abuse, fire, flood, theft, acts of God, neglect, or alteration of the product will not be covered. It excludes any accessories that accompany the product, including bulbs or batteries. This warranty does not cover handling, labour, transportation, or any other cost associated with the installation or replacement of the product.

Artika For Living Inc. will not be held responsible for any direct or consequential damages or injuries related to the use of this product arising from improper use or installation of this product.

For more information, visit www.artika.com.

Contact:

Artika For Living Inc.
1756, 50th Avenue
Montréal (Lachine), Québec
Canada H8T 2V5

Customer Service: Monday to Friday, 9 a.m. - 5 p.m. EST

Phone: 1-866-661-9606

Email: support@artika.com