Artika Aiden LED Ceiling Light

Included Hardware

Installation Overview

What You Will Need

• Screwdriver ?
• Drill
• 1/4 in. drill bit (6.5 mm)
• Pencil ✏️

The installation process involves attaching a mounting bracket to the ceiling electrical box, connecting the light fixture's wires to the house wiring, and then securing the light fixture to the bracket.

Safety Information & Important Notes

⚠️ WARNING: Risk of electrical shock. Turn off breaker at the panel.

Switch off the main electrical supply from the fuse box/circuit breaker before installing the unit or doing any maintenance. Do not use outdoors.

⚠️ CAUTION: If using a dimmer, it must be LED compatible.

IMPORTANT:

The installer and/or user must read, understand, and follow these instructions before installing the product. This product must be properly installed before it is used. If instructions are not followed, the manufacturer will not be held responsible for any problems or product malfunction. Failure to follow installation and/or operating instructions voids the warranty.

It is recommended that this product be installed by a certified electrician. In some states or provinces, it is a legal requirement for this type of product to be installed by a certified electrician, according to the electrical and building codes effective in the region where the unit is used.

Step-by-Step Installation

Step 1: Prepare Ceiling Box

A drill is shown creating holes in the ceiling. Screws (D) are shown being inserted into the mounting bracket (B), which is aligned with the electrical box.

Drill holes in the ceiling for the mounting bracket. Secure the mounting bracket (B) to the electrical box using junction box screws (D).

Step 2: Mount Bracket

Wall anchors (A) are shown being inserted into the pre-drilled holes. The mounting bracket (B) is then secured with retaining screws (C) into the anchors.

Insert wall anchors (A) into the pre-drilled holes. Attach the mounting bracket (B) to the ceiling using retaining screws (C).

Step 3: Connect the Wires

A close-up shows wire connections using wire connectors (E). The white wire is connected to white (N), the black wire to black (L), and the ground wire (G) to ground (G).

Connect the wires using wire connectors (E):

• White (N) house wire to White (N) fixture wire
• Black (L) house wire to Black (L) fixture wire
• Ground wire (G) to Ground wire (G)

Step 4: Install Light Fixture

The light fixture (G) is shown being aligned with the mounting bracket. An arrow indicates pushing the fixture upwards. Canopy screws (F) are used to secure the fixture.

Align the light fixture (G) with the mounting bracket and secure it in place using canopy screws (F).

Features

Tunable White Technology

A diagram shows a color temperature selector with options from 2700K to 5000K, and a brightness adjustment slider.

The Aiden LED ceiling light features Tunable White Technology ?, allowing adjustment of color temperature from warm white (2700K) to cool white (5000K) and brightness control. This feature allows users to customize the lighting to their preference.

Compliance Information

Canada (IC)

Operation is subject to the following two conditions:

1. This device does not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

USA (FCC)

⚠️ WARNING:

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment causes harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Warranty

Artika For Living Inc. offers a three-year (3) limited warranty on manufacturing defects from the date of purchase for residential use only. The warranty is extended to the original owner in the USA and Canada and is non-transferable. It does not apply to retailers, commercial applications, or establishments. The original sales receipt is required for all warranty claims. The remedy under this limited warranty shall be product or part replacement at Artika's discretion and cannot exceed the original purchase price.

This warranty is valid only on products installed in accordance with the building code and laws effective in the region where the unit is used, and in accordance with the provided instruction manual. It does not cover products installed incorrectly or subjected to abnormal use. Product(s) or component part(s) may be required to be returned for inspection and verification.

The warranty does not cover normal wear and tear, misuse, negligence, vandalism, improper maintenance (including surface damage due to chemical interaction or cleaning agents, abrasives, alcohol, or organic solvents), improper handling, accident, abuse, fire, flood, theft, acts of God, neglect, or alteration of the product. It excludes accessories like bulbs or batteries.

The warranty does not cover handling, labor, transportation, or any other cost associated with installation or replacement. This limited warranty is valid in the country of purchase and by Artika authorized retailers only.

Artika For Living Inc. will not be held responsible for any direct or consequential damages or injuries related to the use of this product arising from improper use or installation.

Please visit www.artika.com to discover more about Artika For Living Inc.

Contact Information

Artika For Living Inc.

1756, 50th Avenue
Montréal (Lachine), Québec
Canada H8T 2V5

Phone: 1-866-661-9606

Email: support@artika.com

Website: www.artika.com

Customer Service Hours: Monday to Friday, 9 am - 5 pm EST