Caple FSCHSS9 Conventional Hood

Introduction

Thank you for choosing this Caple extractor hood. To ensure that you get the best results from your new extractor, we strongly suggest that you read this instruction manual thoroughly before use. If treated with care, your Caple extractor should give you years of trouble-free use.

To register ownership, please ensure you complete and return the guarantee card supplied with the appliance or visit www.caple.co.uk and register here.

This instruction manual is designed to provide you with all the required information related to the installation, use and maintenance of the appliance.

This hood is designed to extract unpleasant odours from the kitchen; it is not intended to extract steam. In order to operate the unit correctly and safely, please read this instruction manual carefully before installation and use.

The cooker hood uses high quality materials and is made with a streamlined design. Equipped with an electric motor and centrifugal fan, it provides strong extraction with low noise. It also features non-stick grease filters and an easy installation.

Important Safety Information

This appliance must only be used for the purpose it is intended. Other types of use are not permitted and may prove dangerous. Caple will not be held liable for any damage caused by the incorrect use of the appliance.

Do not use any accessories or attachments not recommended by Caple as this may result in fire, electric shock or injury.

To protect against fire, electrical shock and injury to persons, do not immerse cords or plugs in water or any other liquid.

Never touch the appliance with wet or damp hands.

Never pull the power cable as you could damage it. If the appliance is faulty, do not attempt to repair it. Isolate it from the mains electric supply and contact Caple Service either by phone 0117 938 7420 or email service@caple.co.uk.

Keep all packaging (including plastic bags, polystyrene foam etc) out of the reach and away from children.

Do not rest large or unstable objects on any part of the appliance.

Caple cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that Caple reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance. Under no circumstances should any external covers be removed for servicing or maintenance except by suitably qualified personnel.

• Never let children operate the machine.
• The cooker hood is for home use only, not suitable for barbecuing, restaurants or other commercial purposes.
• The cooker hood and its filter should be cleaned regularly in order to keep in good working condition.
• Clean the cooker hood according to the instruction manual to reduce the risk of fire.
• When using a gas hob, do not leave naked flames under the extractor.
• Before connecting this appliance check that the power supply cord is not damaged.
• If the room where the hood is to be used contains a fuel burning appliance such as a central heating boiler then its flue must be of the sealed or balanced flue type. If other types of flue or appliances are fitted ensure that there is an adequate supply of air to the room.
• The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels.
• Regulations concerning the discharge of air have to be conformed to.
• Do not flambé under the cooker hood.
• Never leave frying pans unattended during use as over-heated fats and oils may catch fire.
• To ensure the best performance, we recommend switching on the extractor 15 minutes before cooking and leave it running 15 minutes after. This will ensure that the air in the kitchen is being circulated before cooking commences and the air is being cleaned after cooking has finished.
• The performance of your extractor will vary depending on a number of factors. These include type of extraction, room volume, length of ducting, ventilation available and the cleanliness of the filters.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• Cleaning and user maintenance must not be made by children without supervision.
• Never immerse the appliance in water.
• This appliance is intended to be used in household and similar applications such as:
  • Staff kitchen areas in shops, offices and other working environments.
  • Farm Houses.
  • By clients in hotels, motels and other residential type environments.
  • Bed and breakfast type environments.
• To avoid all risk, if the power cable is damaged, it must only be replaced by a Caple appointed engineer.
• Appliances can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
• Children must not play with this appliance.
• When not in use and before cleaning, always isolate the appliance from the electrical supply.

Electrical Shock Hazard

Failure to follow these instructions can result in death, fire, or electrical shock.

This appliance must be connected to the mains by a competent person. We recommend that the appliance is connected by a qualified electrician who is a member of the N.I.C.E.I.C who will comply with the I.E.E and local regulations. Electrical information can be found on the rating plate.

As this appliance is Class II ? the extractor does not need any earth connection.

Environmental Protection

Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice. This appliance is marked according to the European directive on Waste Electrical and Electronic Equipment (WEEE).

By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The symbol on the product indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal.

For more detailed information about treatment, recovery and recycling of this product, please contact your local council, your household waste disposal service or the retailer where you purchased the product.

Warranty

Your new appliance is covered by warranty. The warranty card is enclosed - if it is missing, you must provide the following information to your retailer in order to receive a replacement: date of purchase, model and serial number. Registration can also be completed online by visiting www.caple.co.uk.

Ensure you keep your warranty card safe, you may need to show it to Caple Service together with proof of purchase. If you fail to show your warranty card you will incur all repair charges.

Spare parts are only available from Caple Service and spare parts authorised centres.

Declarations of Conformity

CE DECLARATIONS OF CONFORMITY

This appliance has been manufactured to the strictest standards and complies with all applicable legislation, Low Voltage Directive (LVD) and Electromagnetic Compatibility (EMC).

UKCA DECLARATIONS OF CONFORMITY

This appliance has been manufactured to the strictest standards and complies with all applicable legislation.

Technical Fiche

This appliance conforms to all current and applicable energy regulations. To view the Technical Fiche that supports the energy labelling data, please visit the product page on our website www.caple.co.uk.

Installation

Prepare for the Installation

If you have an outlet to the outside, your cooker hood can be connected as per the below picture by means of an extraction duct with an interior diameter of 120mm.

Diagram showing a cooker hood connected to an external duct with an interior diameter of 120mm.

Before installation, turn the unit off and unplug it from the outlet.

Diagram showing a power plug being disconnected from a wall socket.

The cooker hood should be placed at a minimum distance of 65~76cm above the hob. It is the manufacturer of the hob who determines the clearance required and the clearance quoted by the hob manufacturer must be followed. In the absence of any instructions supplied with a gas hob the minimum distance between the hob and the hood must be at least 760mm.

Diagram illustrating the recommended minimum distance of 65-76cm between the cooker hood and the hob.

Installation Method 1: Ducted

1. To install onto the wall, drill 2 holes of Ø8mm in a suitable place according with the centre distance of hole in the back of the cooker hood.
2. Insert the wall plugs into the holes.
3. Insert the screws into the wall plugs and tighten. Put the cooker hood onto the tightened screws.
4. Mark position for the safety screw holes onto the wall and remove the cooker hood.
5. Drill 2 holes of Ø8mm and insert wall plugs into holes.
6. Place the cooker hood onto the tightened screws (see A.).
7. Fix the cooker hood with the safety screws. The two holes are positioned on the back casing, with diameter of 6mm (see B.)
8. Attach the one-way valve to the cooker hood.

Diagram showing two holes drilled into a wall, with wall plugs inserted, ready for screws.

Close-up view of the back of the cooker hood showing mounting points A and B for safety screws.

Installation Method 2: Cupboard Mount

Drill 4 holes of 6mm diameter at the bottom of the hanging cupboard.

Attach the one way valve to the cooker hood, then install the cooker hood onto the bottom of the cupboard, tighten the hood with the 4 screws supplied.

Note:

• The ducting tube is not supplied with the extractor.
• Take off the protective film before installation.

Diagram of the cooker hood with dimensions: height 35.5cm, width 54.5cm, and depth 21.5cm.

Air Extraction Setting

Ducted Installation:

Turn the adjuster to the ducted position, install the outlet, turn on the cooker hood. The air will be extracted to the outside outlet.

Diagram showing the internal adjuster set to the 'ducted' position, with air being extracted outwards.

Recirculation:

The recirculation mode uses a CAP80CF charcoal filter. Turn the adjuster to the indoor position, install the outlet cover onto the round ducting spigot, turn on the cooker hood, then the air can be vented from the front outlet.

Diagram showing the internal adjuster set to the 'indoor' position, with air being recirculated and vented from the front outlet.

Note:

We recommend the ducting does not exceed 2.5 metres in length, to ensure maximum efficiency.

Installing the Charcoal Filter

The charcoal filter is mounted on the back of the grill and must be changed once every 6 months. Replacement CAP80CF charcoal filters can be purchased directly from www.caple.co.uk.

Warning:

The charcoal filter cannot be washed or recycled. It should be changed at most after 120 hours of use (approximately 6 months). The charcoal filter shouldn't be exposed to heat.

To install the filters, simply line up the lugs and push onto the motor. Then twist to lock and secure to the filters.

Diagram illustrating the installation of the charcoal filter by aligning lugs and twisting to lock it onto the motor.

Operation - Push Button Controls

OFF Button

Press the Off button to turn off the extractor.

1 LOW SPEED BUTTON

Press this button to turn the extractor on at the low fan speed. It is suitable for simmering and cooking which does not produce much steam or odour.

2 MEDIUM SPEED BUTTON

Press this button to select the medium fan speed. The airflow speed is ideal for extracting with standard cooking.

3 HIGH SPEED BUTTON

Press this button to select the high fan speed. When a high amount of steam or odours are produced, use the high speed setting for the most effective extraction.

LIGHT BUTTON

Switches the light on and off.

Care and Maintenance

Important:

Before cleaning or maintenance please switch off the electricity supply and remove the plug from the wall.

Regular Cleaning

Use a soft damp cloth with lukewarm mildly soapy water or household cleaning detergent. Never use metal pads, chemicals, abrasive material, abrasive cleaning creams or stiff brushes to clean the appliance.

Cleaning the Grease Filter

Clean the filter every month to help minimise the risk of fire. The filter collects grease, smoke and dust, therefore the filter is directly affecting the efficiency of the cooker hood. If not cleaned, the grease residue (which is potentially flammable) will saturate the filter. It can be easily cleaned with warm water and washing up liquid, alternatively the filters can be cleaned in your dishwasher.

Please ensure no other items are washed with the filters, they must be washed separately to prevent food becoming trapped in the gauze. Cleaning the grease filters in the dishwasher may lead to discolouration, this is normal and is not a fault with the product.

Replacing Your Charcoal Filter

This only applies if you are using the hood in recirculation mode (not vented to the outside). The charcoal filter traps your cooking odours and they need to be replaced, this can vary depending on how frequently the cooker hood is used. We recommend replacing them at least every 6 months.

This extractor uses CAP80CF charcoal filters. Filters can be purchased directly from www.caple.co.uk.

Replacing the Bulb

1. Switch the unit off and unplug the appliance.
2. Remove the aluminium grease filters.
3. Remove the lamp cover by unscrewing the 2 screws.
4. Unclip the light and remove by pressing the metal retaining clips and pushing down.
5. Open clip box (a) and unplug light.
6. Replace with the same type and rated bulb (2W) by following these instructions in reverse.

Diagram showing the components of the lighting unit, including the lamp cover, clip box, retaining clips, and the light bulb. Detail 'a' shows how to release the retaining clips.

Light Source Energy Class

This product contains a light source of energy efficiency class G.

Troubleshooting

If the above table has not solved the problem please contact Caple Service by phone on 0117 938 7420 or by email service@caple.co.uk.

Product Dimensions

Diagram showing the product dimensions: Height 140mm, Depth 500mm, Width 600mm, Duct Outlet Diameter 120mm, Front Grille Width 340mm.

Caple Contact Details

Caple Service
Fourth Way
Avonmouth
Bristol
BS11 8DW

T: 0117 938 1900
E: service@caple.co.uk
www.caple.co.uk