Remote Zoom Control Setup Guide
1. Connect Camera with Receiver
This guide uses the Corona R6FA-SB receiver as an example. Other receivers may be compatible, but ensure they are set to PWM mode. Consult your receiver's manual for specific instructions.
[Image Description: A Corona R6FA-SB 2.4GHz FASST COMPATIBLE receiver, showing multiple channel ports (CH1-CH7-SB) and FCC/CE markings.]
Connect the PWM signal cable from the camera to the corresponding receiver channel (e.g., CH5) and ensure the Ground (GND) connection is also made.
[Image Description: A close-up view of a PWM signal cable connected to a receiver board. The cable is labeled "PWM" and connects to a pin header. A separate wire is connected to the "GND" pin.]
2. Controller Setup
For this setup, the camera is connected to receiver channel CH5. The controller setup is demonstrated using a Futaba T14SG transmitter.
- Perform frequency matching according to your receiver's manual.
- Configure the controller settings as shown in the following steps.
[Image Description: The Futaba T14SG transmitter's screen displaying the "LINKAGE MENU" and "FUNCTION" settings. Key parameters visible include MODEL SEL., REVERSE, FAIL SAFE, SYSTEM, FUNCTION, END POINT, SRVO SPEED, and channel assignments.]
3. Map Channel to Control
Map the camera control signal (e.g., CH5) to a desired button or stick on your transmitter. In this example, CH5 is mapped to the SG stick. Alternative channels can also be used for mapping.
4. Remote Control Zoom
Use the SG stick to control the camera's zoom function.
- When the SG stick is moved down, the camera zoom is set to the default 1x.
- When the SG stick is moved to the middle position, the camera zoom is set to 10x.
