Anker SoundCore mini Owner's Manual
Model: A3101
Safety Instructions
- ⚠️ Avoid dropping.
- ⚠️ Do not disassemble.
- ⚠️ Do not submerge in water.
- ⚠️ Avoid extreme temperatures.
- ⚠️ Do not use the device outdoors during thunderstorms.
- ✅ Use original or certified cables.
- ✅ Do not use any corrosive cleaner/oil to clean.
- ✅ Do not expose batteries to high heat (e.g., direct sunlight, fire).
What's Included
- Anker SoundCore mini Bluetooth Speaker
- Micro-USB charging cable
- Owner's Manual
At a Glance
The SoundCore mini features the following:
- Microphone
- Mode button
- Battery indicator
- Power switch
- 3.5mm Aux input
- Micro-USB charging port
- SD card slot
- Volume buttons
- Multi-function button
- Status indicator
Using Your SoundCore
1. Turn On/Off
Press and hold the Power switch (4) to turn the SoundCore on or off. The status indicator (10) will show the power status.
2. Select Mode
The SoundCore mini supports Bluetooth, AUX-In, SD Card, and FM Radio modes. Plugging in an audio cable or inserting an SD card will automatically switch to Aux or SD card mode, respectively. Press the Mode button (2) to cycle through modes.
a. Bluetooth Mode
When turned on, SoundCore will automatically connect to the last connected device if available. If not, it will enter pairing mode, indicated by a rapidly flashing blue light on the status indicator (10). To pair a new device, disable Bluetooth on the currently connected device or press and hold the Mode button (2) for 3 seconds to re-enter pairing mode. Then, repeat the pairing steps on your device.
- Play/Pause: Press the Multi-function button (9) once. ▶️
- Answer/End Call: Press the Multi-function button (9) once. ?
- Activate Siri/Voice Control: Press and hold the Multi-function button (9) for 2 seconds. ?
- Volume Up/Down: Press the Volume buttons (8). ⬆️ / ⬇️
- Next Track: Press and hold the Volume Up button (8) for 2 seconds. ⏭️
- Previous Track: Press and hold the Volume Down button (8) for 2 seconds. ⏮️
To pair a different device: First, disable Bluetooth on the connected device or press the Mode button (2) for 3 seconds to re-enter pairing mode. Then, repeat the pairing steps.
Connection Problems: If you experience connection issues, remove SoundCore from your device's Bluetooth history, ensure it is less than 3 feet (approx. 90 cm) away, and try pairing again.
b. AUX-In Mode
Connect an audio source using a 3.5mm Aux cable (sold separately). The indicator light will be steady white. When using AUX mode, control audio playback via the connected device.
c. SD Card Mode
Insert a micro SD card (up to 32GB, Class 4 or above) into the SD card slot (7). Supported audio format: MP3. Controls (Play/Pause, Volume, Next/Previous Track) function similarly to Bluetooth mode.
d. FM Radio Mode
Plug in the included Micro-USB cable to act as an antenna for best reception. Press the Mode button (2) to enter FM Radio mode. Use the Multi-function button (9) to scan for stations (press and hold for 2 seconds). Use Volume buttons (8) to adjust volume. Press and hold Volume Up (8) for 2 seconds to go to the next station, and Volume Down (8) for 2 seconds for the previous station.
Charge Your SoundCore
Use the included USB cable to charge your SoundCore. Ensure it is fully charged before first use.
- Charging: Indicator light flashes white. ⚡
- Fully Charged: Indicator light is steady white. ?
- Low Power: Indicator light is red. ⚠️
Specifications
| Specification | Details |
|---|---|
| Input | 5V ⎓ 1A |
| Audio Output | 5 W |
| Battery Capacity | 1800 mAh |
| Charging Time | 2-3 hours |
| Play Time | 15 hours (varies by volume level and content) |
| Size | 67 x 67 x 67 mm / 2.6 x 2.6 x 2.6 in |
| Weight | 215 g / 7.6 oz |
| Bluetooth Version | V4.0 |
| Range | 20 m / 66 ft |
Safety & Compliance
This device complies with FCC Rules Part 15. Operation is subject to conditions that prevent harmful interference. Changes not approved by the responsible party may void user authority. This equipment complies with Industry Canada license-exempt RSS standard(s).
RF Warning: The device meets general RF exposure requirements and can be used in portable conditions without restriction.
Battery Disposal: Dispose of used batteries according to local regulations. Do not discard with household waste.
Trademarks: Bluetooth® word mark and logos are registered trademarks of Bluetooth SIG, Inc.
Declaration of Conformity: Anker Innovations Limited declares that radio equipment type A3101 complies with Directive 2014/53/EU. Full text available at www.anker.com.
Customer Service
For FAQs and more information, please visit:
Warranty: 18-month limited warranty.
Technical Support: Lifetime technical support.
Contact:
- Email: support@anker.com
- Phone (US): 1-800-988-7973 (Mon-Fri 9:00-17:00 PST)
