Coverado Seat Cover Installation Guide for Toyota Tundra

Package Contents

Front Seat Covers

• Headrest Cover x 2
• Backrest Cover x 2
• Cushion Cover x 2

Components

• Strap Chuck x 16
• Strap Hook x 8

Rear Seat Covers

• Headrest Cover x 3
• 40% Backrest Cover x 2
• 20% Backrest Cover x 1
• 40% Cushion Cover x 1
• 60% Cushion Cover x 1

Preinstallation Guide

Strap Preparation

Prepare the straps and hooks as follows:

1. Diagram shows a sequence of steps to prepare the components: a strap hook is bent and then inserted into a strap chuck.
2. Diagram shows a sequence of steps to attach the prepared strap chuck to the car seat, using the strap hook to secure it.

Catalogue Reference

• Front seat cover installation tutorial: Page 2
• Rear seat cover installation tutorial: Pages 3-5

Notice: Please untie all the magic buckles before starting the installation.

Front Seat Installation

1. Place the seat cover over the car seat, starting from the top and working downwards, ensuring it is unbuttoned at the top.
2. Zip the seat cover closed along the side or back.
3. Insert the seat cover's securing chucks into the gap between the seat cushion and the seat back.
4. Place the headrest cover onto the headrest. Attach the rear strap of the headrest cover to the front of the seat back. Then, secure the main body of the headrest cover to the rear of the seat back by following the integrated strap.
5. Position the seat cushion cover. Tuck its securing chucks into the gap between the seat cushion and the seat back. Pull the attached hooks downwards to the underside of the seat and secure them onto the seat's support pole.
6. From behind the front seat, locate the reserved elastic band on the backrest cover and tuck the two chucks from the cushion cover into it.

Rear Seat Cover Installation

40% Rear Seat Cushion Cover

1. Place the 40% rear seat cushion cover onto the seat and tuck its securing strap into the gap between the seat cushion and the seat back.
2. Lift the 40% split rear seat and pull the securing strap out from the gap.
3. Secure the straps. Straps labeled '1' and '2' must be threaded through the designated side strap.
4. Illustration showing the completed installation of the 40% rear seat cushion cover.
5. Lower the 40% split rear seat back into its original position.
6. Adjust the edges of the seat cover for a snug fit.

60% Rear Seat Cushion Cover

1. Place the 60% rear seat cushion cover onto the seat and tuck its securing straps into the gap between the seat cushion and the seat back.
2. Lift the 60% split rear seat and pull the securing straps out from the gap.
3. Secure the straps and buckles, working from bottom to top. Straps labeled '1' and '2' must be threaded through the designated side straps.
4. Illustration showing the completed installation of the 60% rear seat cushion cover.
5. Lower the 60% split rear seat back into its original position.
6. Connect the edges of the cushion cover using the integrated Velcro fasteners.

Rear Seat Back Cover Installation

1. Place the 40% backrest covers onto the respective sides of the rear seat back.
2. Place the headrest covers onto the rear headrests and tuck their securing chucks into the gap between the headrest post and the seat back.
3. Attach the middle backrest cover to the seat back using the provided Velcro fasteners.
4. Secure the middle headrest cover by fastening its buckles.
5. Illustration showing the fully installed rear seat covers.