Coverado Seat Cover Installation
Products: Coverado Oxford Seat Covers
Installation Guide
Follow these steps to install your Coverado Oxford Seat Covers on the front seats of your vehicle. These covers are designed for easy fitting and provide excellent protection for your car's original upholstery.
- Step 1: Initial Placement
Begin by sliding the main seat cover over the headrest of the car seat. Gently pull the cover downwards along the seat back.
- Step 2: Fit Over Seat Back and Cushion
Continue pulling the seat cover down, ensuring it fits snugly over the entire seat back and onto the seat cushion. Adjust the fabric for a smooth fit.
- Step 3: Install Headrest Cover
Take the separate headrest cover and place it over the car seat's headrest. Ensure it is oriented correctly.
- Step 4: Secure Headrest Cover
Fasten the headrest cover securely. This may involve straps, Velcro, or elastic bands, depending on the specific design.
- Step 5: Seat Base Straps Visible
With the main seat cover fitted, you will see straps hanging down from the bottom edge of the seat cover. These are for securing the base.
- Step 6: Locate Attachment Points
Examine the rear and underside of the car seat to identify the points where the seat cover's base straps will attach or be secured.
- Step 7: Route Base Straps
Carefully thread the seat cover's lower straps underneath the car seat, guiding them towards the designated securing points.
- Step 8: Secure Base Straps
Fasten the base straps securely. This is often done by tucking them into the gap between the seat cushion and seat back, using provided clips, or tying them to existing anchor points.
- Step 9: Final Check
The front seat cover is now fully installed. Ensure it is taut, smooth, and securely in place.
Coverado Oxford Seat Covers offer durable protection against spills, dirt, and wear, enhancing the look and longevity of your vehicle's interior.
