Baby Trend HC87916 High Chair

Parts List

• Seat Back x 1
• Height Bracket x 2
• Tray Insert x 1
• Tray x 1
• Upper Frame Assembly x 2
• Seat Back Hinge Rod x 1
• Seat Base x 1
• Crotch Retainer x 1
• Screw (3.5 mm x 10) x 4
• Front Leg x 1
• Rear Leg x 1
• Footrest x 1
• Caster (with brake) x 2
• Front Wheel x 2
• Seat Pad x 1
• Seat Insert x 0
• Basket x 1
• Car Seat Adaptor x 1

Safety Warnings and Precautions

Failure to follow these warnings and instructions could result in serious injury or death.

• Prevent serious injury or death from falls or sliding out. Always secure the child in the restraint system. NEVER leave the child unattended.
• The child should be secured in the high chair at all times by the 5-point restraining system.
• The tray is not designed to hold the child in the chair.
• It is recommended that the high chair be used in the upright position only by children capable of sitting upright unassisted.
• Accessory items may change the balance of the high chair and cause hazardous unstable conditions; use approved Baby Trend toys.
• Ensure the high chair is fully erect and latched in the open position before allowing the child near it.
• Using the high chair with a child weighing more than 40 pounds (18.14 kg) will cause excessive wear and stress.
• The maximum weight for the basket is 5 pounds (2.26 kg). Excessive weight may cause instability.
• NEVER allow your high chair to be used as a toy.
• NEVER use this product if there are any loose or missing fasteners, loose joints, broken parts, or torn mesh/fabric. Check periodically. Contact Baby Trend Customer Service for replacement parts or repair.

For assistance, contact Baby Trend Customer Service at 1-800-328-7363 (8:00 AM - 4:30 PM PST).

Assembly Instructions

Read all instructions BEFORE assembly and USE. Keep for future reference.

Adult assembly is required. Always check that the high chair is locked in the open position before using.

1. Place the Seat Base on a flat surface.
2. Join the Seat Back to the Seat Base using the Seat Back Hinge Rod. Press down on the retainer and insert the rod from right to left.
3. Slide the left and right Height Brackets onto the Seat Base and snap them into place.
4. Slide the Footrest onto the Seat Base and snap it into place.
5. Insert the front tube of the right side Upper Frame Assembly into the corresponding Height Bracket. Squeeze the red release handle and push the tube through the bracket until it locks in the highest position.
6. Repeat step 5 for the left side Upper Frame Assembly.
7. Insert the front legs into the ends of the front tubes of both Upper Frame Assemblies. Ensure push buttons align with holes and are engaged.
8. Insert the rear legs into the ends of the rear tubes of both Upper Frame Assemblies.
9. Attach casters and front wheels to the high chair feet. Ensure they are securely fastened.
10. To attach the Crotch Retainer to the Tray, orient the plastic housing, insert screws (3.5mm x 10), and tighten without over-tightening.
11. Attach the Seat Pad to the Seat Back using the two elastic loops, fitting them over the attachment tabs.
12. Attach the bottom of the Seat Pad to the Seat Base using the two elastic loops, fitting them over the attachment tabs.
13. Insert the Seat Insert onto the Seat Pad.
14. Thread the non-buckle end of the Harness Straps (Harness Attachment Tabs) through the provided slots in the Seat Fabric, Seat Insert, Seat Back, and Seat Base. Rotate the tabs 90 degrees to secure.

Infant Car Seat Attachment: If using as a car seat carrier, adjust the high chair seat to the lowest height position first. Always use the safety belt to secure the infant car seat.

15. To remove the Seat Back: Press down on the hinge rod retainer, slide the rod to the right, pull it out, and lift the seat back away.
16. Position the car seat adaptor bar with the release lever facing forward. Insert the pegs into the corresponding holes on the high chair seat. Push down on the other side and guide pegs until the bar snaps into place.
17. Position the infant car seat facing forward. Lower the car seat so the notch slides onto the adaptor bar and latches. Strap the short clips over the infant car seat through the seat belt slots. Ensure clips are tightly fastened.

Operation and Use

Opening the High Chair: Push legs apart until fully open and locked. Push downward on fold levers to ensure the frame is locked open.

Attaching and Operating the Tray: Line up tray grooves with armrests. Squeeze release handle and slide tray onto armrests. The tray has a 3-position adjustment. Squeeze the handle underneath to adjust position. Release handle and check for secure locking.

Attaching Insert Tray: The dishwasher-safe Tray Insert snaps onto the High Chair Tray. Ensure it snaps securely.

Reclining the Seat: Squeeze the recline lever on the back of the seat and adjust to the desired recline or upright position. Be careful not to catch the child's limbs.

Using the Safety Belt: Place child's arms through shoulder and waist straps. Place crotch strap between legs. Insert harness buckles into the center clasp. Adjust straps for comfort and safety, ensuring a snug fit.

Releasing the Safety Belt: Push the red button on the center clasp to release the buckles.

Adjusting Seat Height: Squeeze the left and right height adjustment levers and adjust to the ideal position. Always ensure the bracket is level and locked before placing the child.

Folding the High Chair: Place the Seat Back in the most upright position. Pull upward on release levers and push rear legs inward until folded. Store the chair safely.

Unfolding the High Chair: Push legs apart until fully open and locked. Push downward on fold levers to ensure the frame is locked.

Care and Maintenance

General Cleaning: Clean high chair and tray after each use with mild dish soap. Use a soft brush, sponge, or cloth. DO NOT submerge in water. Surface clean only.

Harness Straps and Basket: These are NOT washable.

Tray Insert: Dishwasher safe up to 160°F. Do not use scouring pads.

Seat Pad:

• Non-Washable Seat Pad: Use a sponge or cloth with mild detergent for surface cleaning. DO NOT MACHINE WASH.
• Washable Seat Pad: Machine wash COLD DELICATE CYCLE with non-chlorine detergent. DO NOT USE BLEACH. HANG DRY. DO NOT MACHINE DRY.

Basket: The basket is attached by four snaps. Release snaps to remove. Feed snap strips around basket slots and press snaps firmly to attach.