Franke FTU PLUS 3707 XS Installation Manual

Safety Information

⚠️ Warning! Before proceeding with installation, read the safety information in the User Manual.

(Note: Safety information is provided in multiple languages in the original document.)

Parts Included

The following parts are typically included for installation:

• Part A: Screws (2x - 2.9x9.5 mm)
• Part A1: Screws (4x - M4x13 mm)
• Part F: Ducting component
• Part G: Mounting bracket component
• Part I: Fasteners
• Part L1: Screws (4x - 6x70 mm)
• Part O: Ducting component
• Part O1: Ducting component
• Part P: Cover/Finishing piece
• Part W: Securing component
• Part Z: Electrical module

(Diagrams on page 3 show these parts, along with safety icons ? and ?.)

Dimensions and Clearances

Ducting Sizes:

• Ø 120 mm
• Ø 150 mm

Mounting Clearances:

• Minimum 200 mm clearance from ceiling/surface.
• Minimum 550 mm clearance from hob (cooking surface) on sides.
• A 90-degree angle is indicated for positioning relative to the hob.
• A 2-inch clearance is also noted.

(Diagrams on pages 4, 5, and 6 illustrate these measurements.)

Installation Steps

Step 2: Mount Wall Bracket

Position the wall bracket (G) on the wall. Mark drilling points. Drill holes (Ø 10 mm, 4x). Secure the bracket using screws (A). Safety icons ? and ? are shown, indicating the need for protective gloves and tools.

Step 3: Attach Fan Unit

Attach the fan unit to the wall bracket using screws (L1, 4x).

Step 4: Connect Ducting

Connect the appropriate ducting pipes (Ø150 mm or Ø120 mm) to the fan unit using parts F, O, and O1. Ensure a secure fit.

Step 5: Secure Ducting

Secure the connected ducting to maintain stability.

Step 6a: Attach Main Body

Attach the main body of the extractor hood to the wall bracket using parts G and A1 screws (4x - M4x13 mm).

Step 6b/6c: Final Body Attachment

Further secure the main body. This may involve using pliers ? to adjust or fix components. Part P (cover) is attached using screws (A, 2x - 2.9x9.5 mm).

Step 7: Final Mounting Adjustments

Make final adjustments to the hood's position and secure it firmly to the wall bracket using parts G and A1 screws (4x - M4x13 mm).

Step 8: Electrical Connection

Connect the electrical components. Insert the module (Z) into its designated slot. Connect the wires labeled "Lux" and "Cmd" as per the diagram. A wrench ? icon is shown, indicating tools may be needed.

Step 11: Final Checks

Perform final checks to ensure all connections are secure and the appliance is stable. Part W is used for securing.

Manufacturer Information

Franke S.p.a.

Via Pignolini, 2

37019 Peschiera del Garda (VR)

Website: www.franke.it

Document Reference: 991.0590.978_03 - 220128 - D000000005962_02