Operating Instruction

Initialization

Insert three AA-sized alkaline batteries into the battery compartment on the rear panel. Subsequently, plug the connector of the rear panel into the socket of the front panel. Press the reset button until one long "beeps" are heard, at which point the lock is initialized. After initialization, all programmed passcodes, access cards, and fingerprint templates will be erased. (The lock is pre-initialized at the factory.)

Power

Reset button

Networking of devices

Tip: This product is a Bluetooth smart cabinet lock. The App administrator is the final administrator of the lock. The owner of the Bluetooth smart cabinet lock must download the Smart Life App or Tuya App for binding.

1. Please download and install the Smart Life App or Tuya Smart from the Apple Store or mobile app market.
2. After the installation is complete, follow the prompts to register and log in.
3. Users can also scan the following QR code to download and install the application:

[QR Code for App Download]

Add bluetooth lock

Add the lock to App (Must be in the initialization state) Please enter "8#" on the lock first, and then follow the steps below; (please operate within 1 minute).

Step 1: In the Tuya App, click "+" and click "Add Device".

Step 2: Wait for the device "Smart locker lock" to be found and click on it to start pairing.

[App Screenshot: Add Device Screen]

[App Screenshot: Device Found Screen]

Unlock with temporary password

Step 3: Unlock with temporary password. The App can set a temporary password, time-limited password, one-time password, and dynamic password. Once the setting is successful, enter the password to unlock.

[App Screenshot: Temporary Password Setup]

Add fingerprint

Step 4: Click "Add Fingerprint" and the green light of the smart lock starts flashing. Put the finger on the lock's fingerprint sensor and read the same finger 8 times (different angles).

[App Screenshot: Add Fingerprint Screen]

[App Screenshot: Fingerprint Placement Guide]

Add Code

Step 5: Click "Add code" and the green light of the smart lock starts flashing.

Step 6: Enter an 8-10 digit password, click "Save".

[App Screenshot: Add Code Screen]

Add Card

Step 7: Click "Add card" and the green light of the smart lock starts flashing. Put the card on the lock's keypad.

[App Screenshot: Add Card Screen]

Check unlock Log

Step 8: Check unlock Log. When connected to Bluetooth, the App can check the unlock log.

[App Screenshot: Unlock Log]

Installation steps

1. Drill holes: Drill a hole of 16mm diameter and 2 holes of 8mm diameter in the door from the door edge of 46.5mm.

2. Insert plug: Put the plug through the door hole and insert it into the socket of the front panel.

3. Fix panel: Fix the front panel and the rear panel on the door with 2 pcs M4 screws.

4. Load batteries: Load 3 pcs AA alkaline batteries in the battery holder.

5. Install the latch stopper: Draw a line at the center of the latch. When installing the latch stopper, please reserve some space to install it, otherwise the cabinet door cannot be closed; Tilt angle large side on the outside.

6. Fix latch stopper: Use 2pcs M3.5*16 screws to fix the latch stopper to the door.

[Diagram: Installation Steps]

Diagram showing hole placement and component installation.

Gap between the door: 46.50mm

Battery box: 3pcs AA alkaline dry batteries

Lock body

Latch stopper

M3.5*15 screw

M4 screw

Front panel

Keep the thickness of the door

Technical parameters