SuperFish Start Heater

General Instructions

Read this manual carefully before using this device. Keep this manual for future reference.

Meaning of Symbols

Warning Symbols

DANGER!

This means an imminent danger due to electric current. Failure to follow the safety instructions can result in serious or fatal injury and/or serious damage to the product or environment.

WARNING!

This means a dangerous situation. Failure to follow the safety instructions can result in moderate or minor personal injury and/or damage to the product or environment.

CAUTION!

This means a dangerous situation due to potential surfaces becoming hot. Failure to follow the safety instructions can result in burns and/or fire damage.

Device Symbols

This device may only be used inside the house for aquarium purposes.

This device has protection class II.

The maximum immersion depth of this device is 1 metre.

This device is waterproof and can be fully submersed (IP68).

This device complies with all applicable EU standards (CE).

This device may not be disposed of with normal household waste but must be collected separately for recycling. [Recycling symbol ♻️]

Use

Only suitable for indoor use for aquarium purposes.

Safety

Always follow the safety instructions below for safe use of the device. Failure to follow these instructions may endanger persons or the environment.

• This device must be protected by an earth leakage relay breaker with a leakage current of a maximum of 30mA.
• Ensure the voltage shown on the label matches the mains supply voltage.
• Protect the socket and plug against moisture. Use a drip loop [Illustration showing a drip loop to prevent water reaching the socket] to ensure that water cannot reach the socket via the power cord.
• Don't use the device if it is damaged. Return the device to your dealer for repair or recycling. The power cord cannot be replaced. If the cord is damaged, the device should be recycled.
• In the event of glass breakage or leakage of the heater, immediately disconnect the plug from the socket. Allow the heater to cool for 15 minutes, then remove it from the water.
• It is not possible to repair cracked glass. Glass breakage is never covered by warranty.
• Always switch off all devices in the aquarium before maintenance. Disconnect the plug(s) from the socket.
• Never insert the plug in the socket when the heater is not fully submerged.
• Only use the heater if it is fully submerged in the water.
• Never remove the heater from the water when the plug is in the socket.
• First remove the plug from the socket and let the heater cool for 15 minutes. Then remove the heater from the water.
• This device can be used by children aged from 8 years and above, persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge, if they have been given supervision or instructions concerning the use of the device in a safe way and understand the hazards involved. Children shall not play with the device. Cleaning and maintenance of the device shall not be done by children without supervision.
• Modifications to the device may affect the safety. The warranty will also expire.

Function

The Start Heater is an aquarium heater with an adjustable thermostat (17-35°C). Tropical fish live in warm water, with this underwater heater you can heat the aquarium water to the desired constant temperature.

Installation

• Install the heater in the aquarium with the supplied clips and suction cups.
• Install the heater upright at a minimum depth as indicated on the heater. The maximum operating depth is 1 metre.
• Allow the thermostat of the heater to acclimate for about 5 minutes with the water temperature.
• Turn on the heater by plugging it into the socket. Ensure that no water can get close to the socket.
• Set the desired water temperature (between 17-35°C) with the temperature knob.
• Always check the water temperature with an aquarium thermometer. Even though the heater has a temperature accuracy of ± 0.5°C, small deviations are always possible.

Maintenance

• Clean the heater regularly using a sponge and a descaling agent. Dirt, lime deposits or algae can accumulate on the glass of the heater. After cleaning, rinse the heater thoroughly with clean tap water.

Recycling

This symbol indicates that this product (if it is discarded) may not be disposed of with normal household waste. Instead it must be handed in at an official collection centre (e.g. HWRC). Or can be returned to the dealer when purchasing a similar new product. Follow the applicable rules in your country for the separate collection of electrical and electronic products. Separate collection and recycling are better for the environment, public health and reduces waste.

Warranty

2 years manufacturer's warranty on materials and construction defects. Devices must be returned complete with all components, accompanied with an official proof of purchase confirming a purchase date for any warranty claims. Incomplete devices of which parts are missing, and devices without proof of purchase are not eligible for warranty. After receiving and checking, we will determine whether the device will be repaired or replaced.

For a device repaired or replaced under warranty, the remaining time of the original warranty period applies.

Carefully read the instructions on installation, use and maintenance. Damage due to incorrect use, damage due to contamination or not cleaning the device and damage to the cord are not covered by the warranty.

Always keep the proof of purchase, without proof of purchase the warranty will be void!

Technical Specifications