ROVSUN Owner's Manual & Operating Instructions
Model No.: G57000416
Product Features
- Heavy Duty welded Coated Steel Frame
- 30 Quart Aluminum Stock Pot with Lid
- Steamer Basket
- 10 Quart Aluminum Fish Fryer Pan & Strainer Basket with Heat-Resistant Handle
- 5 PSI CSA Certified Regulator with Hose
- 55000 BTU cast iron burner
- Poultry Rack with 3 pieces of metal skewer
- Rack Lifter
- 1 OZ. Marinade Injector
- 12" Probe Thermometer
[Fry Button] [Deep Fry Button] [Boil Button]
Important Safety Information
For Outdoor Use Only
Read all Warnings and Operating Instructions before use and retain for future reference.
WARNING: Propane gas is highly flammable and under pressure in the cylinder or tank. Do Not store or use gasoline or other flammable liquids or vapors in the vicinity of this stove. If you detect the odor of gas, immediately evacuate the enclosed area and contact the appropriate authorities/professionals.
[Danger Symbol: Flammable Hazard]
FOR YOUR SAFETY
Do Not store or use gasoline or other liquids with flammable vapors in the vicinity of this or any other appliance.
IF YOU SMELL GAS:
- Do Not attempt to light appliance.
- Extinguish any open flame.
- Disconnect from fuel supply.
Document Version: 09/22/2022
Assembly Instructions
Tools Needed for Assembly
- Adjustable Wrench
Assembly Steps
Diagram Description: The diagram shows the components for assembling the stove stand. It includes a metal stove stand, a cast iron burner with a threaded pin, a heat shield, a flange nut, and a lock nut.
- Unscrew the pre-assembled lock nut and flange nut from the threaded pin of the cast iron burner. Then insert the threaded pin of the burner through the hole of the support bar of the stove stand.
- Insert the heat shield onto the threaded pin of the burner then screw with an M6 flange nut and an M6 lock nut.
*Make sure all hardware are used and tightened with a wrench.
Operating Instructions
Preparation
- Place stove on a level, stable surface.
- Attach propane hose to the brass stove inlet fitting.
- Make sure the propane bulk tank valve is closed.
- Attach propane hose to the outlet of the propane tank.
- Slowly open propane tank valve and check for leaks by applying a small amount of liquid soap and looking for bubbles to appear.
Note: When connecting the Hose to the unit, insert the male fitting of the hose. Tighten the fitting onto the throat of the burner using a wrench. Do not overtighten. You should be able to turn the air control panel.
Lighting Instructions
- Read instructions before lighting.
- When you are sure there are no leaks, turn the cylinder valve and regulator control valve on the hose to the closed position.
- Have a fireplace match or long-nosed lighter lit and over the burner from the SIDE. Keep hands and face away from the burner.
- Slowly open gas supply until the burner ignites. Keep hands and face away from the burner.
- Adjust the regulator control valve for desired flame height.
- When finished using the cooker, turn off the gas cylinder valve first. It will take a few seconds for the fire to go out and for the propane gas to bleed from the hose and regulator assembly. After the fire is completely out, turn the regulator control valve to the OFF position.
- To re-light, repeat steps 1-6. Always use CAUTION as the cooker will be hot.
- If ignition does not occur in 5 seconds, turn the burner control(s) off, wait 5 minutes, and repeat the lighting procedure.
Storage
- DO NOT leave propane tank attached to stove during storage or transport.
- Wipe the burners, steel cooking grate, and propane hose before storing.
- It is suggested to store stove and hose in a nylon storage bag to keep it clean.
CAUTION: DO NOT attempt to connect your camp stove to a natural gas supply. Use only with propane, hose, and regulator supplied with the stove and an approved bulk propane tank.
Diagram Description: The diagram shows a 20 lb. LP Gas Cylinder connected to the stove via a hose. It indicates that the gas supply is opened by turning the valve counter-clockwise. Approximate hose length or clearance is noted as .61m (24").
Warranty and Service
The warranty period of the product is 365 days from the date of purchase. If the product has any problem, please feel free to reach out to us and we will work out solutions for you ASAP. And please include the order number in the email when you contact us so that we can get the order and product info and help you resolve the issue faster.
[Question Mark Icon] If you have any questions, please contact us at support@rovsun.com.
