Eachine Wizard X220s

QUICK START GUIDE

1.0 Knowing your aircraft

Aircraft Components:

2.0 Knowing your remote controller

The remote controller is equipped with functional switches for primary flight/high-level flight modes, which are easy to operate. You may select the flight mode suitable for your flying skill.

Remote Controller Layout:

Control Movements:

3.0 Specifications

Eachine Wizard X220S

Wheelbase 220mm
Frame arm 4mm light material
Weight (without battery and camera mount) 356g
Take off weight 561g
Package weight 1728g
Material Light composite material
Frame kit features 4mm thickness, 15mm width frame arms; camera angle scale; 30° camera mount for Runcam 3 Gopro session; Anti-vibration sponges.

Eachine MN2206 2300KV motor

KV 2300
Max thrust 1100G
Length 35MM
NO. OF cell 3-5S
Diameter 28MM
Framework 12N14P
Shaft 3MM
Propeller 5 inch
Weight 28g

Eachine 30A BLHELI_S 4 in 1 ESC

Con. current 30A
Peak current (10S) 35A
Input voltage 2-5S
BEC No
Programming YES
Firmware blheli_s
Weight 28g
Size 36*36MM

Eachine 1179 800TVL CCD camera

Color Purple
Sensor CCD
Resolution (horizontal center) 800TVL
Shell size 25mm*25mm
Weight 11g
Resolution PAL: 1980H×1080 (2MP) NTSC: 1980H×1080V (2MP)
Format PAL/NTSC switchable
Video output 1.0Vp-p/75Ω
AGC 0.25/0.50/0.75/1.00 adjustable, up to 55dB
AWB ON/OFF
Exposure mode Electron exposure
Electronic shutter 1/50(1/60) - 1/100000 S
Gamma correction 0.45/1.0
Synchronization method Internal synchronization
Lens Standard 2.8mm lens
Working voltage DC12V (Wide Voltage, measured that can work in 5-13V)
Working current 70mA (low power consumption)
Working temperature -20℃-60℃
Humidity 0%~98%
Special feature Strong backlighting effect

5.8G 72CH 25MW 200mw 600MW switchable transmitter

Video Format NTSC/PAL
Channel 72CH
Operating Temperature -10~85℃
Connector SMA Female (Inner hole)
Antenna Connector SMA male (Inner needle)
Band CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8
Band-A 5865 5845 5825 5805 5785 5765 5745 5725
Band-b 5733 5752 5771 5790 5809 5828 5847 5866
Band-E 5705 5685 5665 5645 5885 5905 5925 5945
Band-F 5740 5760 5780 5800 5820 5840 5860 5880
Band-r 5658 5695 5732 5769 5806 5843 5880 5917
Band-U 5325 5348 5366 5384 5402 5420 5438 5456
Band-o 5474 5492 5510 5528 5546 5564 5582 5600
Band-L 5333 5373 5413 5453 5493 5533 5573 5613
Band-H 5653 5693 5733 5773 5813 5853 5893 5933

Omnibus F4 V3 flight controller

Size 36x36mm
Mount holes 30.5x30.5mm
Features STM32 F405 MCU, Runs Betaflight 3.0.1 firmware, supports faster loop time. Uses F4 MCU to control OSD over SPI bus in DMA mode. OSD configuration included in Betaflight GUI. SBUS/PPM input. 6PWM output. No BARO. SPI Sensor MPU6000. Includes 128Mbit Flash. Use BEC for the FC. Supported by BETAFLIGHT and dRonin.

iRangeX iRX-i6X 2.4GHz 10CH remote control

Channel 6-10 (Default 6)
Model Type Fixed-Wing/Glider/Helicopter
RF Range 2.408-2.475GHz
RF Power < 20dBm
RF Channel 135
Bandwidth 500KHz
2.4GHz System AFHDS 2A / AFDHS
Modulation Type GFSK
Stick Resolution 4096
Low Voltage Warning < 4.2V
DSC port PS/2 Port PPM
Chargeable No
Antenna Length 26mm (Dual Antenna)
Weight 392g
Power 6V DC 1.5AA*4
Display STNTransflective Display, LCD 128x64 Lattice, VA 73x39mm, LCD with white backlight
Size 174x89x190mm
On-line Update Yes
Color Black
Certificate CE0678, FCC ID: N4ZFLYSKYI6X

iRangeX iR-A8S receiver

Channels PPM 8CH
Model type Multi-rotor
Frequency range 2.408-2.475GHz
Band width 500KHz
Band number 135
RX Sensitivity -92 dBm
2.4GHz system AFHDS 2A
Modulation type GFSK
DSC port PPM
Transfer method FHSS
Data output 1.5mm*3 Pin PPM
Antenna length 26mm (Not including brass contacts)
Input power supply 4.0-8.4V
Display method LED
No ground interference (Transmitting and receiving 1 m from the ground) >300m
Working current 40mA
Channel delay <15mS
Size 20*14*5.3mm
Weight 1.2g
Certificate CE0678, FCCID: N45ZA8S00

1500mAH 4S 14.8V 75C battery

Capacity(mAh) 1500
Cells (s) 4
Weight (g) 177
Length(mm) 80

4.0 Motor Unlock/Lock

Motor Unlock

Place the throttle lever at the lowest point, set the rudder rocker to the right and hold for more than two seconds. The red state indicator turns blue, and the buzzer gives the "BB" sound to unlock the motor.

Right-hand throttle: Rudder rocker, Throttle rocker

Left-hand throttle: Rudder rocker, ELEV rocker

Motor Lock

Put the throttle rocker at bottom and the rudder handle to the left. The status indicator light blue to red, and "BB" from the buzzer sound when the lock for motor. The push up the throttle rocker motor won't turn.

Right-hand throttle: Rudder rocker, Throttle rocker

Left-hand throttle: Rudder rocker, ELEV rocker

5.0 Notes for flight

  1. It is intended for pilots aged 14 or above with model hobby experience.
  2. Only fly in dry weather with low wind. Do not fly in rain, snow, or heavy foggy conditions.
  3. An open field lawfully permitted must be selected for flying, in line with your mental condition and flying skill.
  4. Always keep a certain distance from aircraft and keep it from high-speed rotating parts, such as propellers or brushless motors.
  5. Do not fly around high-voltage power lines, cellphone basestations, or radio towers, as they are likely to interrupt your communication.
  6. Always check local laws before flying; never fly an illegal flight.

6.0 Charging

  1. Connect the power adapter to mains power (100~240V 50/60HZ). When its output terminal is connected to the charger, the charger's green LED light flashes.
  2. Plug the charging terminal of the battery into the charger.
  3. The red LED light remains on during battery charging, and the green LED light remains on when charging is completed.

PDF preview unavailable. Download the PDF instead.

Eachine Wizard X220s Manual Corel PDF Engine Version 17.1.0.572 CorelDRAW X7

Related Documents

Preview Eachine Wizard X220HV FPV Racing Drone Quick Start Guide
This quick start guide provides essential information for setting up and operating the Eachine Wizard X220HV FPV racing drone. It details the package contents, specifications for key components like the frame, motors, ESC, flight controller, VTX, camera, and Bluetooth module, along with basic flight instructions and safety tips.
Preview Eachine Wizard X220HV Quick Start Guide
A comprehensive quick start guide for the Eachine Wizard X220HV FPV racing drone, detailing its components, specifications, and basic operation.
Preview Eachine X220 v2 FPV Racing Drone User Manual and Flight Guide
Comprehensive user manual and flight guide for the Eachine X220 v2 FPV Racing Drone, covering setup, operation, safety, battery management, and advanced features. Includes details on the Flysky FS-i6X remote control and other components.
Preview Eachine X220 V3 FPV Racing Drone Quick Start Guide
A comprehensive quick start guide for the Eachine X220 V3 FPV racing drone, detailing package contents, component specifications, and initial setup procedures using the Betaflight configurator.
Preview Eachine V-tail 210 Quick Start Guide
This document is the Quick Start Guide for the Eachine V-tail 210 FPV Racing Drone. It covers general introduction, specifications, parts identification, remote controller details, receiver configuration for ARF and RTF versions, safety precautions, battery charging, flight preparation, motor arming/disarming, firmware flashing, OSD setup, and Bluetooth connectivity.
Preview Eachine Wizard TS130 FPV Drone Quick Start Guide
A concise guide to setting up and operating the Eachine Wizard TS130 FPV drone, covering frame kit, motor, ESC, flight controller, VTX, camera, and basic flight procedures.
Preview Eachine Racer 180 FPV Racing Drone Instruction Manual
Comprehensive instruction manual for the Eachine Racer 180 FPV racing drone, covering specifications, assembly, operation, charging, and safety guidelines.
Preview Eachine Tyro99 210mm DIY FPV Racing Drone - Build Your Own FPV Racer
Explore the Eachine Tyro99, a 210mm DIY FPV racing drone kit designed for enthusiasts. This package includes all essential components for building a high-performance FPV quadcopter, featuring a carbon fiber frame, powerful 2206 2150KV motors, a 4-in-1 30A BLHeli_S ESC, and an F4 flight controller with integrated OSD. Perfect for learning and competitive FPV racing.