MOES Wireless Controller User Manual

1. Introduction

Welcome to the MOES Wireless Controller user manual. This device is designed to enhance your smart home experience by providing convenient control over various smart devices and scenes. It utilizes Zigbee 3.0 technology for reliable and efficient communication within your smart home network.

This controller is compatible with the Tuya Smart Life app, allowing you to create custom automation scenarios and manage your devices remotely.

2. What's Included

Inside the package, you should find:

• MOES Wireless Controller (EB14-250214)
• User Manual (this document)
• Mounting Accessories (e.g., adhesive tape or screws)

3. Getting Started

3.1 Battery Installation

The wireless controller is powered by a replaceable button cell battery.

To install or replace the battery:

1. Gently open the controller casing. A small slot is usually provided for prying it open.
2. Insert one CR2450 battery ?, ensuring correct polarity (+/-).
3. Close the casing securely.

Note: Battery life may vary depending on usage.

3.2 Pairing with Your Zigbee Hub

This controller requires a compatible Zigbee 3.0 hub to operate.

Follow these steps to pair the controller with your hub:

1. Ensure your Zigbee hub is powered on and in pairing mode (refer to your hub's manual for instructions).
2. Press and hold the main button on the wireless controller for approximately 5 seconds ▶️. The LED indicator (if present) may flash to confirm it's in pairing mode.
3. The controller should appear in your Zigbee app (e.g., Tuya Smart Life) within a few moments. Follow the app's prompts to complete the pairing process.

Tip: If pairing fails, ensure the controller is within range of the hub and try again.

4. Usage and Features

The MOES Wireless Controller typically features multiple buttons or a rotatable knob, each capable of performing different actions based on press type (single press, double press, long press).

Common actions include:

• Single Press: Activate a pre-defined scene or toggle a device.
• Double Press: Trigger a secondary scene or function.
• Long Press: Enter pairing mode, activate an emergency scene, or perform another specific function.

You can customize these actions within the Tuya Smart Life app:

1. Open the Smart Life app and navigate to the controller device.
2. Tap on the device to access its control interface.
3. Look for options like "Tap-to-Run" or "Automation" to assign functions to button presses.
4. Create scenes (e.g., "Movie Mode," "Good Morning") and link them to the controller's actions.

Example Scenario: A single press of the controller could turn on your smart lights, while a long press could activate a "Good Night" scene that turns off all lights and locks doors.

5. Specifications

6. Troubleshooting

Issue: Controller not responding.

Possible Solutions:

• Check battery status and replace if necessary.
• Ensure the controller is within range of the Zigbee hub.
• Try re-pairing the device with the hub.

Issue: Pairing failed.

Possible Solutions:

• Make sure the hub is in pairing mode.
• Reset the controller by pressing and holding the button for 10 seconds ▶️ [reset-indicator].
• Ensure no other devices are interfering with the Zigbee signal.

For further assistance, please consult the support section within the Tuya Smart Life app or the MOES support website.