Pet Stain Eraser PowerBrush First Use Guide & Charging Light Indication

Charging

Upon removing your machine from the box, insert the charger.

For maximum run time, charge the machine for 4.5 hours prior to use.

Note: It could take up to 2 hours for the machine to go from 1 to 2 battery lights while charging.

Formula Tank

Open the Formula Tank Cap and fill with Formula to the Formula dot.

Close the Formula Tank Cap until it clicks and is securely closed.

A hand is shown filling the formula tank. An arrow indicates the fill line marked 'FORMULA'.

Cleaning and Operation

Turn the Machine on.

The Brush Roll will automatically start spinning. To turn the Brush Roll off, press the Brush button.

The control panel features a power button [power button], a spray button [spray button], and a brush button [brush button]. Arrows indicate their functions.

Spray Formula in the desired area using the Spray Button.

Scrub the area with the rotating PowerBrush. Keep the nose of the machine flat on the surface.

For best suction, tilt the machine slightly forward and pull backwards while firmly pressing the suction channel to the cleaning area.

The 'Suction Channel' is the part of the machine that draws up dirt and liquid. It is shown pressed against a surface.

Emptying the Dirty Tank

Make sure to empty the Dirty Tank when it reaches the MAX FULL line.

For instructions on Emptying the Dirty Water Tank, refer to 'After Cleaning Care'.

The dirty water tank is depicted, showing a 'MAX FULL' indicator line. The tank is partially filled with dirty water.