PULL-DOWN KITCHEN FAUCET INSTALLATION INSTRUCTIONS

Notes before installation:

1. Please check that all components are present.
2. Before installation ensure that all feed lines are clear of debris and on/off valve is present.
3. Ensure water pressure is between 20-125 PSI (includes combination of hot and cold feed lines).
4. Pictures in the manual are general in content and may not represent exactly your purchased faucet. If you are having difficulties please contact a professional plumber.
5. If you will be away from home for an extended period you should shut off the main water supply.

Daily maintenance:

1. Use a soft cloth and vinegar to remove hard-water spots.
2. Check aerator (if present) regularly for calcium build up when water stream is not optimum.
3. DO NOT use caustic cleaning products as the use will break down finish and will void the product warranty.
4. Acceptable cleaners include vinegar or mild non-abrasive liquid detergents.
5. If the water pressure appears to be less than optimum remove, inspect, clean or replace aerator.

Tools we will need:

• Adjustable Wrench ?Adjustable Wrench
• Phillips Screwdriver ?Phillips Screwdriver
• Silicone Sealant ?Silicone Sealant
• Safety Goggles ?Safety Goggles

Installation Steps:

1. Step 1:

   Remove the rubber washer, metal washer and locking nut from the faucet. Install faucet through center hole.

   Diagram: Faucet body detached, showing rubber washer, metal washer, and locking nut. Faucet is then shown inserted through a hole.

2. Step 2:

   Re-install the rubber washer followed by the metal washer and lock-nut. Hand tighten, then tighten further using a screwdriver to tighten lock-nut screws.

   Diagram: Faucet installed through base. Washers/nut reattached underneath. Screwdriver shown tightening lock-nut screws.

3. Step 3:

   Attach the pull-down hose to the outlet tube.

   Diagram: Pull-down hose connecting to the underside of the faucet spout. Close-up of connection.

4. Step 4:

   Install the weight ball to pull-down hose in place.

   Diagram: Weight ball attached to the pull-down hose to aid retraction.

5. Step 5:

   Attach flexible hose to water supply.

   Diagram: Flexible supply line hose from faucet connecting to water supply valve.

6. Step 6:

   Remove the sprayer head and turn on faucet for 1-minute to flush debris. Close the handle and re-assemble spray head.

   Diagram: Sprayer head unscrewed. Faucet running water to flush lines. Sprayer head reattached.