Tory™ High Lumen Tape Light

PARTS / TOOLS NEEDED:

• High Lumen Tape Light
• Mounting Channel (purchased separately)
• UL Class 2 Power Supply (purchased separately)
• Butt Splices (not provided)
• Alcohol Wipes (not provided)

Safety Instructions

• Disconnect power before installing, adding or changing any component.
• To avoid a hazard to children, account for all parts and destroy all packing materials.
• Do not install any luminaire assembly closer than 6" from any combustible materials.
• Lights are not rated for wet location installation.
• Note, this light is susceptible to damage by electrostatic discharge, use care when handling. [ESD Caution]
• For safety purposes, ITC recommends tape light installations be used with a Class 2 power device. For installations without a Class 2 power device, it is highly recommended that appropriate fusing be used, to be determined by tape light length.

Installation Steps

Step 1

Determine the installation location and clean the surface using alcohol wipes (not provided). For more information on surface prep please review the 3M website*. Start at the wired end and begin peeling back the tape.

Image Description: A hand is shown peeling the backing off an LED tape light strip, preparing it for installation.

*3M Website Surface Preparation Guide

Step 2

Remove paper backing from tape before placing in track then press the light into the aluminum mounting channel or onto a piece of 0.1"H x 1/2"W (3mm x 12mm) aluminum flat bar. Continue working along the light and peeling the paper as you go. Only pull back a few inches at a time to prevent the tape light sticking to itself.

In order to properly dissipate the heat, the tape light must be installed in/on an aluminum channel or flat bar. Failure to properly install light will void the warranty.

Image Description: LED tape light is being pressed into an aluminum mounting channel or flat bar. The backing paper is partially peeled away.

Step 3

Follow the wiring diagram below to wire the light to your system.

Wiring Diagram Description: A diagram illustrates the connection between a Power Supply (24V-110V) and the Tape Light. The Power Supply has terminals for Load (L), Neutral (N), and Green (G). The Tape Light has a Black wire (Negative) and a Red wire (Positive). The Black wire connects to the Negative terminal of the power supply, and the Red wire connects to the Positive terminal. The diagram also indicates connecting the Power Supply to a 110V-277V power source.