Ubiquiti UniFi Ethernet Surge Protector: Outdoor Installation Guide

Components and Tools

This guide outlines the installation of the Ubiquiti UniFi Ethernet Surge Protector (UACC-ETH-SP-PRO). Ensure you have the following components and tools:

• Ubiquiti UniFi Ethernet Surge Protector
• Grounding Wire
• M3 screws (2x)
• M5 screws (1x)
• Mounting hardware (provided)
• Tools: Screwdriver, potentially a drill

Installation Steps

Follow these steps for a secure and effective installation:

1. Prepare the Grounding: Connect the grounding wire to a suitable grounding point. The surge protector requires proper grounding for effective operation. The diagram shows a grounding wire with a Ø5 mm (03/16") terminal.

   Diagram Description: A visual representation of connecting a grounding wire to a grounding point.

2. Mount the Surge Protector: Securely mount the surge protector to a surface using the provided hardware. The diagram indicates mounting holes and screw sizes (M3 and M5).

   Diagram Description: An isometric view of the surge protector being mounted, showing screw placements.

3. Connect Ethernet Cables: Connect your incoming Ethernet cable to the 'IN' port and the outgoing cable to the 'OUT' port of the surge protector. Ensure a secure connection.

   Diagram Description: An illustration showing Ethernet cables being plugged into the 'IN' and 'OUT' ports of the surge protector.

4. Connect to Ground: Ensure the grounding wire is properly connected to the surge protector's grounding terminal.

   Diagram Description: A close-up view of the grounding wire connected to the surge protector's grounding lug.

5. Connect to Network Devices: Connect the 'OUT' port of the surge protector to your network device (e.g., UniFi Cloud Gateway, Switch, PoE Device).

   Diagram Description: A network diagram showing the surge protector connected between an incoming Ethernet line and a network device.

6. Verify Connections: Double-check all connections to ensure they are secure and correctly made.

   Diagram Description: A checkmark symbol indicating verification of connections.

7. Final Assembly: Complete any remaining assembly or securing steps as per the specific installation environment.

   Diagram Description: A final view of the installed surge protector.

Network Configuration Example

The surge protector is designed to be placed in-line with your network connection, typically between the outdoor Ethernet cable entry point and your network equipment.

Example Setup:

• Incoming Internet connection
• UniFi Cloud Gateway
• Switching
• PoE Device

The surge protector should be installed before the connection to the UniFi Cloud Gateway or other network devices.

Diagram Description: A simplified network topology showing the surge protector integrated into the network path.

Support

For further assistance, visit the Ubiquiti Help Center or contact Ubiquiti Support.