STOCKHOLM 2025 Table Lamp
Important Safety Information
⚠️ For indoor use only.
The external flexible cable or cord of this luminaire cannot be replaced. If the cord is damaged, the luminaire shall be destroyed.
Assembly Instructions
Parts Included
- 1x Lamp pole (long, hollow cylinder)
- 3x Securing clips (small, circular piece with prongs)
- 1x Base cover (flat, rectangular, creased)
- 1x Cable management strip (flat, rectangular)
Illustration shows a screwdriver and screw with a cross mark, indicating these are not used in assembly.
Illustration shows figures contemplating assembly, one confused (❓), another consulting instructions and the IKEA logo, suggesting seeking help or using IKEA resources.
Step 1: Prepare Socket Housing
Insert the lamp pole into the socket housing assembly. Rotate the pole to secure it.
Illustration shows the lamp pole being inserted upwards into the socket housing. Circular arrows indicate a twisting/rotating motion to secure.
Step 2: Assemble Base and Pole
Feed the electrical wire through the base and into the pole. Insert the pole into the base. Ensure correct wire connection.
Illustration shows the main lamp pole being inserted downwards into the base. A magnified view shows the electrical wire being fed through a connector. Warning symbols (❌) highlight incorrect methods for wire connection or pole insertion.
Step 3: Guide Wire
Guide the electrical wire down through the base of the lamp.
Illustration shows a hand guiding the electrical wire downwards through the base of the lamp.
Step 4: Attach Cable Management
Peel the protective backing from the cable management strip and attach it to the base of the lamp.
Illustration shows the cable management strip (1x) with its backing being peeled off, and then being pressed onto the base of the lamp.
Step 5: Connect Pole to Socket Assembly
Screw the lamp pole into the socket housing assembly. Rotate to secure.
Illustration shows the lamp pole being screwed into the socket housing assembly. Circular arrows indicate a twisting/rotating motion to secure.
Step 6: Place Lampshade
Lower the lampshade onto the lamp structure.
Illustration shows the cylindrical lampshade being lowered onto the top of the lamp structure, aligning with the socket housing.
Step 7: Secure Lampshade
Insert and rotate the three securing clips to fasten the lampshade to the socket housing.
Illustration shows a close-up of three securing clips (3x) being inserted into slots on the socket housing and rotated to lock the lampshade in place.
Step 8: Install Light Bulbs
Screw light bulbs into the sockets.
Illustration shows hands screwing light bulbs (?) into the lamp sockets.
Step 9: Attach Base Cover
Place the base cover onto the base and secure it with the provided fasteners.
Illustration shows the base cover being placed onto the lamp base. A magnified view shows three fasteners (3x) being inserted and rotated to secure the cover.
Operation
The lamp is now assembled and ready for use. The light can be turned on and adjusted via the switch/dimmer mechanism.
Illustration shows the fully assembled lamp emitting light. A close-up shows a rotating dial, indicating a switch or dimmer control.
