Baby Trend Sit-N-Stand® DX Deluxe Tandem Stroller
Instruction Manual
Warranty Information
DO NOT RETURN YOUR PRODUCT TO THE STORE. PLEASE CONTACT BABY TREND FOR REPLACEMENT PARTS, SERVICE AND REPAIR.
The Baby Trend® warranty covers workmanship defects within the first 180 days of purchase. It is voided by misuse, abuse, abnormal use, excessive wear and tear, improper assembly, negligence, environmental exposure, alteration, or accident, or if the serial number has been altered or removed. Any damage to property during installation is the sole responsibility of the end user.
Customer Service can be contacted at 1 (800) 328-7363, Monday through Friday, between 8:00 am and 4:30 pm PST. Return Authorizations are required prior to returning product(s). Warranty is valid only in North America.
Important Safety Warnings
General Safety
- Always follow all instructions to ensure your child's safety. Keep these instructions for future reference.
- Failure to follow instructions could result in serious injury or death. Avoid serious injury from falling or sliding out; always use the safety harness and ensure children are properly positioned.
- Never leave children unattended.
- Exercise care when folding and unfolding the stroller to prevent finger entrapment.
Weight Limits & Usage Restrictions
- Do not place purses, shopping bags, parcels, diaper bags, or accessory items on the stroller, as they can change the balance and cause instability.
- Maximum weight for the storage basket: 5 lbs (2.26 kg).
- Maximum weight for parent tray and child tray: 3 lbs (1.36 kg).
- Maximum weight for seat belt storage pocket (for seat belt only): 1 lb (0.45 kg).
- Excessive weight can cause a hazardous, unstable condition.
- Ensure the stroller is completely opened and locked before allowing a child near it.
- Maximum weight for the front seat: 50 lbs (22.68 kg).
- Maximum weight for the rear seat: 50 lbs (22.68 kg).
- Maximum weight for the platform/jump seat: 60 lbs (27.21 kg).
- The rear stand-on platform/jump seat is designed for a child at least 2 1/2 years old and not over 40 inches (101.6 cm) tall.
- Total weight of children exceeding 110 lbs (49.89 kg) may cause excessive wear and stress, leading to a hazardous condition.
- NEVER use the stroller on stairways or escalators.
- NEVER allow your stroller to be used as a toy.
Care and Maintenance
- To clean, use only mild household soap or detergent and warm water on a sponge or clean cloth.
- Regularly check for loose screws, worn parts, torn material, or stitching. Replace or repair parts as needed.
- Discontinue use if the stroller malfunctions or becomes damaged. Contact customer service for repair or replacement parts.
Product Identification
Model: SS74 Sit-N-Stand® DX Deluxe Tandem Stroller
Contact Information:
- Baby Trend, Inc.
- 1607 S. Campus Ave., Ontario, CA 91761
- Phone: 1-800-328-7363 (8:00 am - 4:30 pm PST, Monday-Friday)
- Website: www.babytrend.com
Assembly Instructions
Parts Identification
- Stroller Frame
- Canopy
- Child Tray
- Parent Tray
- Front Wheels
- Rear Wheels
- Platform
- Foot Rest
- Cup Holders (Optional Accessory)
Step-by-Step Assembly
- Attaching Front Wheels: Unlock the red release lever. Unfold the stroller frame by sliding the thumb trigger and squeezing the pull trigger while pulling backward on the handle. Lean the stroller back, align the front wheels with the front leg tubes, and push down until they lock securely. Tug on each wheel to ensure they are securely attached.
- Attaching Rear Wheels: Position the rear axle over the rear leg tubes with brake pedals facing backward. Push down on both sides simultaneously with equal pressure until they lock into place.
- Attaching Foot Rest: Push the foot rest downward until it snaps onto the U-shaped frame cross member.
- Attaching Parent Tray: Position the tray so its hinges face forward. Snap the parent tray to the stand at the top of the frame. Ensure the tray is securely latched.
- Attaching Child Tray: Push the child tray downward onto each side of the front armrests until both side snaps lock into place. Ensure the tray is securely latched.
- Accessing Child Seat: To access the child seat, pull one side of the release lever located on the underside of the child tray and lift upward. The tray will lift and rotate out of the way to allow access to the front and rear seats.
- Rotating Child Tray: To attach an infant car seat, rotate the child tray to the vertical position by pressing the red buttons on both sides and rotating down 90 degrees.
- Removing Child Tray: Pull both release levers located on the underside of each side of the tray and lift upward.
- Attaching Cup Holders (Optional Accessory): Push the cup holder downward and onto each side of the front armrests until it snaps into place.
- Attaching Canopy: Line up the male fittings on the canopy with the slots on the armrest and push both fittings downward until snapped into place. To open, push forward on the front edge while holding the rear. To fold, pull backward on the front edge. To remove, press the snap button under the armrest and pull.
- Attaching Platform: Squeeze both locking clips with both hands while holding the platform vertically. Rotate the platform downward until it rests on the axle rod, then release the clips to secure.
- Engaging Brakes: Apply light downward pressure to the brake lever on each rear wheel. The stroller may require slight forward or rearward movement to align the brake teeth with the wheel brake cluster. Ensure the stroller does not move and both brakes are properly applied. To release, gently lift the brake lever.
- Securing Child with 5-Point Harness: Select the loop position that places the shoulder strap level with, or below, the child's shoulder. Feed the shoulder strap under the correct loop. Adjust harness slot by unhooking the shoulder strap from the crotch buckle and feeding it through the harness spread slots (accessed from the rear of the seat). Reattach the strap. Carefully place the child in the stroller seat. Bring the safety harness around the child's waist and over the shoulders. Place the crotch strap between the child's legs. Insert the male end of each shoulder/waist belt into the buckle on the crotch strap. Tighten the harness to be snug around the child's waist and over the child's shoulders.
- Releasing Harness Buckles: Apply pressure to both sides of each male clip until the clip is released. This requires moderate effort to prevent accidental release by the child.
- Attaching Infant Car Seat (Travel System): Strap the safety belt over the infant car seat through the seat belt slots. Connect the buckles together. Tighten the strap so the infant car seat is snug and cannot move. It is very important that the infant car seat strap is always tightly fastened around the infant car seat. Store the safety belt when not in use.
- Securing Child with Jump Seat 3-Point Harness: Have the child sit on the jump seat facing backward. Secure the child with the jump seat 3-point harness. Adjust the belt to be snug around the child's waist.
- Securing Stand Feature Safety Belt: Secure the stand feature safety belt behind the child and engage the buckle. This is the same belt used for the rear infant car seat.
- Reclining Front Seat: The front seat has two recline positions. To recline, rotate the recline bar and press backward on the seat back. To place the seat in the upright position, press upward on the seat back while rotating the recline bar.
- Attaching Front Infant Car Seat: Recline the front seat back. Position the infant car seat facing toward the rear of the stroller, aligning the seat shell with the front child tray and latching it into place. Secure the car seat with the safety belt, ensuring it is tightly fastened.
- Removing Infant Car Seat: Squeeze the release handle located at the foot-end of the seat and carefully lift upward on the seat.
- Sitting Child on Jump Seat: Have the child sit on the jump seat facing backward. Secure the child with the jump seat 3-point harness. Adjust the belt to be snug around the child's waist.
- Standing on Platform: Position the child on the platform on the back of the stroller, ensuring the child is standing facing forward with hands holding the frame. Secure the stand feature safety belt behind the child and engage the buckle. Ensure the child's feet are fully on the platform at all times.
- Folding Stroller: Close the canopy. Pull the stroller backward several inches to rotate the front wheels forward. Slide the thumb trigger to the left, squeeze the pull trigger, and push forward on the handle to fold. Once folding begins, release the red handle and push forward until folded. Lock the release lever so the stroller stands freely.
Care and Maintenance
Seat Pad: To clean the seat pad, use only mild household soap or detergent and warm water on a sponge or clean cloth.
General: Regularly check your stroller for loose screws, worn parts, torn material, or stitching. Replace or repair parts as needed. Discontinue use of the stroller should it malfunction or become damaged.
Customer Service
If you experience any difficulty with assembly, missing parts, or use, please DO NOT return this item to the store. Retail stores are unable to properly assist you. Contact Baby Trend Customer Service directly for assistance.
Call toll-free 1-800-328-7363, Monday - Friday, between the hours of 8:00 a.m. and 4:30 p.m. PST.
Visit www.babytrend.com for more information.
