Waterdrop Pitcher Filtration System

Owner's Manual

Can TDS indicate the water quality?

TDS refers to Total Dissolved Solids, including all minerals such as sodium, calcium, magnesium, etc.

Milk TDS:1000~3000
Milk powder TDS:>2000
Coffee TDS:150~400
Mineral water TDS:200~500

TDS level does not fully indicate the quality of the water. It is improper to use TDS to measure the water filtered by this product. Only the Reverse Osmosis Filtration System can really reduce TDS. This product adopts coconut shell activated carbon to effectively adsorb contaminants and heavy metals while retaining beneficial minerals in the water.

Thank you for choosing our product

Our pitcher delivers clean, healthy and great-tasting water for you and your family by offering household water filters.

The product contains a non-replaceable battery.

System is tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of the claims specified on the Performance Data Sheet, and to NSF/ANSI 372 (≤0.25% lead).

Contents

What's Included in the System:

Care and Safety Information

Getting Started/Instruction for Use

  1. Step 1: Wash your hands, then remove filter from filter box.
  2. Step 2: Please soak it in cold tap water for 10 minutes to remove bubbles before use to activate the filter and ensure the best filtration performance. [Figure 1.1]
  3. Step 3: Hand-wash pitcher, lid and reservoir with a mild detergent. Don't put it in the dishwasher or use abrasive cleaners. Rinse thoroughly with water after washing.
  4. Step 4: Install filter into reservoir. Press firmly to ensure a tight seal. [Figure 1.2]
  5. Step 5: Fill the reservoir with cold tap water. Discard the first two pitchers of filtered water.
  6. Step 6: Hold the button for 5 seconds until the blue light flashes to activate the indicator. [Figure 1.3]

Note: Repeat this step after each new filter replacement.

Status Indication light Remaining life(day)
Good Blue stay on for 5 seconds >10
Replace soon Blue flash 6 times ≤10
Replace now Red stay on for 10 seconds ≤0

When you have filtered 200 gallons of water or the filter life indicator red light is on, whichever comes first, you should change your filter.

Change Water Filter

Water filter replacement consult steps 1 to 6

Change Filter Life Indicator

The filter life indicator is replaceable. Replace it by squeezing the clamping jaw. [Figure 1.4]

During the reinstallation, make sure that the clamping jaw is inserted into the groove completely.

Correctly dispose of the filter indicator

If the battery expires, dispose the indicator according to all applicable provision and regulation.

Technical Specifications

Questions and Answers

Q: Why does the water flow get slow?

A: The filter cartridge may be clogged. Please check the indicator to see if it's time to change the filter cartridge. If yes, please replace the filter cartridge immediately. If not, take out the filter and shake it intensely in order to shift the granules inside, which will improve the speed of water flow.

Q: Why does the water taste bad?

A: The product is unclean, or the filter cartridge is not installed properly. It could also be time to change the filter cartridge. Please clean the pitcher and install the cartridge correctly or replace the filter cartridge.

Q: My filter indicator is not working, I cannot see the color of the indicator!

A: The battery might be out of power. Do not worry, the filter life indicator is replaceable. If it's in the warranty period, we can replace it for free.

Q: Why doesn't the TDS value be reduced after filtration?

A: TDS stands for total dissolved solids. It is composed of inorganic salts and a small amount of organic matter. This filter cannot lower the TDS value because it can remove harmful substances while keeping beneficial trace elements such as potassium, sodium, magnesium, and calcium, which can increase the TDS value. Please choose our RO system if you are looking for physical removal of TDS.

3 Months Quality Assurance

We promise your water filter system for 3 months from the date of purchase (except for the filter cartridge which is assured for 30 days) against all defects in materials and workmanship, when used in compliance with the owner's manual.

If the product proves to be defective within 3 months from the date of purchase, please contact our customer service. During the quality assurance period, we will replace or repair any part which is deemed to be defective, if product has not been subjected to tampering, alteration or improper use after delivery, and has not been repaired by the manufacturer.

The product is not promised against misuse, use in abnormal operation temperature conditions, conditions outside listed operating parameter or use in commercial operations.

We are not responsible for damage in transit and claims for such damage.

If you have any further questions, please call us for free +1-888-352-3558 (U.S.). Our professional team will take care of your problem in a timely manner.

Performance data sheet

System Model No. : WD-PT-07L, WD-PT-07W, WD-PT-07C, WD-PT-07B, WD-PT-07R

Substance reduction

The system has been tested and certified by the NSF International according to NSF/ANSI Standard 42 and NSF/ANSI Standards 372. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for the water leaving the system, as specified by NSF/ANSI Standard 42. While testing was performed under standard laboratory conditions, actual performance may vary.

Substance Average Product Water Concentration Inf. Average Max Permissible Product Water Concentration NSF Specified Challenge Concentration Ave. % Reduction NSF Reduction Requirements NSF Test Report
Chlorine Taste and odor 0.05 mg/L 2.0 mg/L N/A 2.0 mg/L ± 10% 96.7% ≥50% J-00355920

System to be used with municipal or well water sources treated and tested on regular basis to ensure bacteriological safe quality. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.

Testing was performed under standard laboratory conditions, actual performance may vary.

Manufacturer Technical Support

Tel: +1-888-352-3558 (U.S.)

E-mail: CT@waterdropfilter.com

Qingdao Ecopure Filter Co., Ltd.

Models: WD-PT-07B, B0DKSVFY33, B0C8J9GP55, B07C3P2RZP, B087F8126N, B0CMCPVH7P, B0891QZ9PT, B08Z7391YV, B0CDC5L13C, WD-PT-07B Water Filter Pitcher, WD-PT-07B, Water Filter Pitcher, Filter Pitcher, Pitcher

PDF preview unavailable. Download the PDF instead.

C1qpTYoYynL Adobe PDF library 17.00 Adobe Illustrator(R) 24.0

Related Documents

Preview Waterdrop Pitcher Filtration System Owner's Manual
Comprehensive owner's manual for the Waterdrop pitcher filtration system, detailing setup, usage, care, safety information, technical specifications, and troubleshooting. Learn how to maintain your water filter for optimal performance and water quality.
Preview Waterdrop Water Filter Pitcher Owner's Manual
This manual provides instructions for using and maintaining the Waterdrop Water Filter Pitcher, including setup, filter replacement, and troubleshooting. It also details the product's specifications and NSF certifications.
Preview Waterdrop Water Filter Pitcher User Manual and Performance Data
Comprehensive guide for the Waterdrop water filter pitcher, including setup instructions, care information, troubleshooting, and performance data. Certified by NSF International.
Preview Waterdrop Brand Cooperation Manual: Leading Residential Water Treatment Solutions
Explore the Waterdrop Brand Cooperation Manual, detailing their leading position in residential water treatment solutions, product offerings, and distributor support programs. Learn about their innovative technology, global presence, and commitment to quality.
Preview Waterdrop Pitcher Filtration System Owner's Manual
Owner's manual for the Waterdrop pitcher filtration system, covering setup, usage, filter replacement, and troubleshooting. Includes information on TDS and water quality.
Preview Waterdrop WD-G3-CB Replacement Filter Installation Guide
Step-by-step instructions for installing the Waterdrop WD-G3-CB replacement filter for WD-G3-W reverse osmosis water filtration systems. Includes maintenance tips and FAQs.
Preview Waterdrop WD-G3-CF Replacement Filter Installation Instructions
Detailed instructions for installing the Waterdrop WD-G3-CF replacement filter for the Waterdrop Reverse Osmosis Water Filtration System. Includes steps, maintenance, and troubleshooting.
Preview Waterdrop WD-G3-N3CB Filter Installation Instructions
Comprehensive guide for installing the Waterdrop WD-G3-N3CB replacement filter for Waterdrop Reverse Osmosis Water Filtration Systems. Includes filter life, installation steps, maintenance, and troubleshooting.