Tow-Trust Towbars

Issue 2

TFD6VK FORD B-MAX 2012>

BUMPER REMOVAL:

1. Remove four fixings around the boot opening, six fixings along the lower edge and two fixings from each wheel arch.
2. Carefully unclip bumper from the vehicle using a bumper removal tool. (You may find it easier removing the rear tail lights when unclipping the bumper).
3. Remove bumper impact beam. (This is not refitted with the Towbar assembly)

TOWBAR INSTALLATION:

1. Insert Items B into each correct chassis member and fix in place using Items F and Items K. (You may gain access to the forward N/S mounting point by removing the fuel filler pipe clamps).
2. Using Items G with Items L fix Items C to the vehicle rear panel.
3. Insert Item A between Items B and fix in place using Items H and Items K.
4. Using Items E with Items M and Items J with Items M fix Item D and Item N to Item A.
5. Fully tighten all nuts and bolts ensuring the Towbar is rigid, square and secure.
6. Refit the rear bumper.

Diagram of Towbar Assembly

The diagram shows the Tow-Trust TFD6VK towbar assembly for a Ford B-Max. Key components labeled include the crossmember (A), handed side arms (B), handed rear panel brackets (C), and detachable housing (D). Various bolts, nuts, and washers (E, F, G, H, J, K, L, M) are shown connecting these parts. A flip-up socket plate (N) is also depicted. The diagram illustrates how these components are attached to the vehicle's chassis and rear panel, with arrows indicating connection points and the orientation of parts.

A close-up view shows the detachable towbar mechanism with the tow ball attached to the housing.

Notes:

1. Recommended Torque Setting for M12 Grade 10.9 -139 Nm. (For other Torque Settings see notes overleaf.)
2. Nose load limits and vehicle manufacturers trailer / caravan weight limits must be observed.