Hompany SmartVac 11

Installing Desired Cleaning Accessory

To install a cleaning accessory, align the accessory with the main unit and push until it clicks. Repeat for any extension tubes or other attachments.

Diagram shows the process of attaching different cleaning accessories to the vacuum cleaner body, including the main unit, extension tubes, and floor brush. Arrows indicate the direction of connection, and "Click" labels confirm secure attachment.

Power mode and speed switch

The vacuum cleaner features an ON/OFF button and a Switch Button to control power and speed modes.

Operation Modes:

• Boot into "MID" Mode.
• Touch the "UP" Key to set to "MAX" Mode.
• Touch the "UP" Key again to switch to "MIN" Mode.

The display shows battery percentage and current mode (MIN, MID, MAX). Arrows indicate the function of the UP button for mode selection.

Recharging

Recharging on the storage wall-mount: Attach the vacuum cleaner to the wall-mount for charging.

Charging separately: Connect the charger directly to the vacuum cleaner's charging port.

Power display: The display shows the current battery level as a percentage (e.g., 30%, 100%, 60%). It indicates charging status such as "Fully charged" or "Charging from low".

Empty the dust bin

Follow these steps to empty the dust bin:

1. Release the dust bin.
2. Open the dust bin lid and empty the contents.
3. Close the dust bin lid.
4. Reattach the dust bin to the vacuum cleaner.

Diagrams illustrate the process of detaching the dust bin, opening it, emptying the debris, and reattaching it. A "MAX" indicator shows the fill line for the dust bin.

Clean the Electric Floor Brush

Warning: Ensure the vacuum cleaner is turned off before cleaning the floor brush.

1. Detach the electric floor brush from the main unit.
2. Remove any tangled hair or debris from the brush. A cleaning tool is provided for this purpose.
3. If necessary, rinse the brush under cold water.
4. Allow the brush to air dry completely for at least 24 hours before reattaching it.

Diagrams show the floor brush being detached, cleaned with a tool, rinsed, and air-dried.

Dust Cup Cleaning

IMPORTANT! Wash filters with cold water at least every month. Ensure the filters are completely dry before refitting.

1. Remove the dust cup and filters.
2. Wash the filters with cold water.
3. Allow the filters to air dry completely for at least 24 hours.
4. Reassemble the dust cup and filters once dry.

Diagrams show the dust cup and filters being removed, washed, and dried. A warning symbol indicates the importance of complete drying. A red cross symbol indicates that the filters should not be used while wet.

Remove the Dust Cup

To remove the dust cup, press the release button and slide the dust cup away from the main unit. The internal components, such as the filter assembly, can also be removed for cleaning.

Diagrams illustrate the process of detaching the dust cup and then removing the internal filter components.

Prohibited operations

• Do not use the SmartVac 11 near open flames.
• Do not store the SmartVac 11 near heat sources.
• Do not put your hands near the brush bar when the SmartVac 11 is running.
• Not applicable for picking up liquids.
• Not applicable for picking up burning objects.

Support

For any questions, please contact the Hompany Official Customer Service:

• EN: support@hompany.top
• EU: service@hompany.top