AGM Watch Legion User Manual
Charging
When the battery is low, please charge the watch immediately.
The watch supports charging via a charging stand. Ensure the charging adapter and stand are kept dry and are not touched with wet hands. Do not expose them to rain or other liquids. The working temperature of the watch is 0°C to 45°C. If the ambient temperature is too high or too low, the watch may not function correctly.
Safety Instructions
- When measuring heart rate, keep your wrist still.
- Avoid wearing the watch too tightly during daily use. Keep the contact area dry and clean, and regularly clean the band with water. If there are signs of redness or swelling in the skin contact area, stop using the watch immediately and seek medical attention.
- Use the included charging stand to charge the watch. Only use a power adapter that meets local safety standards or is certified and provided by a qualified manufacturer.
- The watch has a built-in battery. Do not disassemble or replace the battery yourself to avoid damage. Only authorized service providers can replace the battery. Using the wrong type of battery can cause potential danger or personal injury.
- Do not disassemble, puncture, strike, crush, or throw the battery into fire. If the battery shows signs of swelling or liquid leakage, stop using it immediately.
- Do not throw the watch or its battery into fire to prevent explosion.
- This watch is not a medical device. Any data or information provided by this watch should not be used as a basis for diagnosis, treatment, or prevention of diseases.
- The watch and its accessories may contain small parts. Keep the watch out of reach of children to prevent choking or other hazards. This watch is not a toy and should only be used by children under adult supervision.
- Misuse or improper handling of the battery can lead to overheating, leakage, or explosion. To prevent possible injury, follow these instructions: Do not squeeze or puncture the battery. Do not short-circuit the battery or expose it to water or other liquids. Keep the battery away from children and fire. Do not place the battery in extreme high temperatures or very low atmospheric pressure.
- If the battery is damaged, or if you discover any discharge or foreign object accumulation on the battery wires, stop using it immediately. It is recommended to charge the battery every three months to prevent overcharging.
- Do not dispose of batteries in landfill waste. When disposing of the battery, comply with local laws and regulations.
How to Wear
For daily use, wear the watch comfortably on your wrist, about one finger's width away from the wrist bone. Adjust the band so that the heart rate sensor can collect data normally. Note: Wearing the watch too loosely may affect the heart rate sensor's data collection.
How to Connect
Download and install the "AGM Nexus" APP to better manage your watch, log in to your account, and enjoy more services. The APP version may be updated; follow the current APP version's prompts. Long press the function button to turn on the watch. Scan the QR code displayed on the watch with your mobile phone to download and install the "AGM Nexus" APP. You can also download and install the APP from the app store or scan the QR code below. Open the "AGM Nexus" APP and log in to your account. Select "Add Device" and follow the instructions to add your watch.
Note: During pairing, ensure your phone's Bluetooth is on and the watch is well connected to the phone. If you cannot find the watch when adding the APP, or cannot connect to the phone during use, press and hold the watch's power button for 5 seconds to reset it to factory settings, and try again.
How to Use
- Open Control Panel: Swipe up from the bottom of the main screen.
- View Notifications: Swipe down from the top of the home screen.
- Switch Widgets: Swipe left or right on the home screen page.
- Back: Swipe from the left edge to the right when on other screen pages.
Adjust & Install/Remove Band
Adjust the buckle position according to your wrist circumference. Align the band's slot with the watch and insert the band into the watch until you hear a click. You can pull the band to check if it is securely installed. To install or remove the band, refer to the illustration below.
Global Positioning System (GPS & A-GPS)
The watch supports Global Positioning System (GPS) tracking. When you engage in outdoor sports like running, GPS will automatically start and notify you when positioning is successful, and stop tracking after you stop exercising. An open outdoor field is the best place for GPS tracking; in crowded conditions, raising your arm can help GPS positioning better. It is recommended to start exercising only after GPS is active.
The watch has an assisted GPS (A-GPS) function, which can accelerate GPS positioning using data directly from GPS satellites. Ensure your watch is connected to your phone via Bluetooth, so data can be automatically synchronized from the "AGM Nexus" APP to your watch, and A-GPS data will also be updated automatically. If data is not synchronized for seven consecutive days, A-GPS data will expire. If so, you need to obtain positioning information again. You can update the positioning information on the watch's outdoor sports page.
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. The device has been evaluated to meet general RF exposure requirement. The device can be used in an uncontrolled environment without restriction.