Hooke Road BXG.3066 Rear Bumper Installation Guide
For Jeep Wrangler JL & Unlimited 2/4 Doors
Package Contents
| Qty | Part Name | Size(mm) | Visual Representation |
|---|---|---|---|
| 6 | Hex Head Flange Bolts | M14*40 | [Bolt Icon] |
| 2 | Hex Bolt | M8*20 | [Bolt Icon] |
| 2 | Split Lock Washer | D8 | [Washer Icon] |
| 2 | Flat Washer | M8*16*1 | [Washer Icon] |
| 2 | Flange Hex Lock Nuts | M8 | [Nut Icon] |
| 8 | Button Head Socket Cap Bolts Screws | M4*16 | [Bolt Icon] |
| 1 | L-Wrench | M4 | [L-Wrench Icon] |
| 4 | Sensor Brackets | N/A | [Sensor Bracket Image] |
| 8 | Cable Ties | N/A | [Cable Tie Image] |
| 1 | D-rings | N/A | [D-ring Image] |
Illustration of the Hooke Road Rear Bumper, D-ring Mount, and License Plate Bracket.
Tools Required
- Drive Socket Ratchet Wrench
- 5mm Hex Bit Socket
- 21mm Shallow Socket
Installation Details
Installation Time: Approximately 1 hour. 1-2 people may be needed. Installation time can vary based on mechanical skill level.
(Please verify all parts are present and read instructions carefully before starting installation!)
To view the electronic version (BXG.3066), please refer to the original documentation as QR codes are excluded from this HTML conversion.
Installation Steps
Step 1: Preparation
Before installing, ensure the vehicle is parked in a safe and level location. Remove the original car rear bumper.
[Image: Rear view of a Jeep Wrangler with the original bumper attached.]
Step 2: Radar Harness and Sensor Brackets
Remove the lights from the bumper. Insert the plug of the original car radar harness into the corresponding radar socket. Secure the radar to the rear bumper using the sensor bracket and fasten with M4*16 screws to prevent shaking or damage during driving.
[Image: Close-up of hands connecting radar harness to the bumper and attaching sensor brackets.]
Step 3: D-ring Mount Installation
Install the D-ring mount onto the factory vehicle mounting beam using M14*40 hex head flange bolts. Tighten the screws securely.
[Image: Close-up of D-ring mount being attached to the vehicle's mounting beam with bolts.]
Step 4: License Plate Bracket Installation
Install the license plate bracket onto the bumper using M8*20 screws for assembly. Tighten them securely. This step uses the following hardware: (2) M8*20 Hex Bolts, (2) D8 Split Lock Washers, (2) M8*16*1 Flat Washers, (2) M8 Flange Hex Lock Nuts.
[Image: Illustration showing the license plate bracket being attached to the bumper with screws, and a separate image of the assembled bracket with lights.]
Step 5: Bumper Mounting
With assistance, lift the bumper. Align it with the original vehicle mounting holes and secure it using M14*40 hex head flange bolts. Adjust the gap from the vehicle and tighten the screws.
[Image: Rear view of a Jeep Wrangler with the new Hooke Road bumper being attached, showing alignment with mounting holes.]
Step 6: D-ring Installation
Install the D-rings into the bumper.
Step 7: Completion
The installation is complete. Enjoy your new Hooke Road product for off-road adventures!
Important Notes
- The product parts in this instruction may differ slightly from actual product contents but generally do not affect installation.
- Please contact your distributor if you have any questions about your purchase.
