JisuLife Handheld Fan Life7 User Manual

Introduction

Please read this manual carefully before use. Ensure you use it in strict accordance with the requirements stated in the manual, and keep the manual for future reference.

Appearance Description

• Air outlet: Where the air is expelled.
• Display screen: Shows operational status and battery level.
• Fan speed/power percentage: Indicates the current fan speed or power output.
• Power/speed button: Used to turn the fan on/off and cycle through speed settings.
• Rear cover (removable): Covers the internal components, can be removed for cleaning or battery access.
• Air inlet: Where the fan draws air from.
• Screws: Used to secure covers.
• Switch: Likely refers to the power/speed button.
• Non-slip pad: Located at the base to prevent sliding.
• Type-C connector: Port for charging the device.

Pre-use Warnings

1. Before turning on, check the product and charging cable for damage. Ensure they are in good condition and assembled correctly.
2. Before charging, verify that the voltage of the power source matches the product's rating label.
3. Do not disassemble, modify, or repair the product to avoid electric shock and fire hazards. Seek repair from a service center designated by the original dealer or manufacturer.

Operating Instructions

A. Power/Speed Setting

Short press the power/off button to cycle through five fan speed settings and turn it off. Long press at any speed to turn it off.

B. Screen Display Status

The screen provides information on battery level and fan speed. Specific displays occur during power on, setting speed, power off, battery status checks, low battery warnings, charging, and when fully charged.

• Power On: Displays current battery charge level for 5 seconds, then switches to fan speed display.
• Setting Speed: Displays current fan speed. During charging, it switches back to charging display after 5 seconds.
• Power Off State: Double-clicking the button shows the current battery level for 5 seconds before the display turns off.
• Battery Display: When powered on, shows current battery level (switches to fan speed after 5 seconds). Double-clicking while fan speed is displayed shows battery level again.
• Cannot Start with Low Battery: If the battery is depleted, pressing the button shows 0% battery, the battery icon blinks, and the display turns off.
• Low Battery Warning: If the battery level is below 10%, the battery icon continuously blinks in fan speed mode, and the single-digit battery level indicator and battery icon blink in battery status mode.
• Charging: The single-digit battery level blinks. When the fan speed is displayed, the battery icon blinks.
• Fully Charged: The 100% battery level remains lit, the battery icon remains lit, and turns off after the power input is disconnected.

Note: If the battery is charged to less than 15% and used during charging, only the first fan speed is available.

C. Fan Operation

1. Hold the handle for operation.
2. Rotate the fan head to a 100° angle and place it on a flat surface for use.

How to Clean

Removing the Rear Cover

Note: Before removing the rear cover, turn off the power and wait for the fan to stop completely. Use a screwdriver to unscrew the screws under the rear cover. Then, twist the rear cover counter-clockwise until you hear a "click" sound to open it.

Cleaning and Maintenance

1. Ensure the power is disconnected before cleaning the product.
2. The rear cover can be washed with water. The fan blades and grille can be wiped with a clean cloth. After cleaning the grille, rear cover, and fan blades, let them dry completely before reinstallation.
3. Do not use water or other liquids to clean electrical components such as the motor or switch.
4. Do not touch power and electrical components with wet hands or a damp cloth.

Rear Cover Installation

Align the edge of the rear cover, insert it vertically downwards. Hold the rear cover frame with both hands, twist it clockwise until you hear a click. Then, use a screwdriver to screw in the screws under the rear cover to complete the process.

Battery Removal

The battery must be removed before disposing of the product. Ensure the product is turned off before removing the battery. Dispose of the battery safely in accordance with local regulations.

1. Using a tool, remove the left and right handle covers of the fan, and unscrew the left and right screws (refer to Figure 1).
2. Remove the non-slip pad, unscrew the fan head cover screws, and remove the head cover (refer to Figure 2).
3. Using a tool, pry open the rear cover of the fan handle, disconnect the plug, and remove the battery for safe disposal according to local regulations (refer to Figure 3).

[Description of Figure 1: Shows removal of fan handle covers and screws.]

[Description of Figure 2: Shows removal of the non-slip pad and fan head cover screws.]

[Description of Figure 3: Shows prying open the fan handle rear cover, disconnecting the plug, and removing the battery.]

Safety Precautions

To ensure safe usage and prevent injuries and property damage to yourself and others, adhere to the following safety measures. Improper use without following safety warnings may lead to accidents.

1. This product is not a children's toy. Ensure infants and children do not play with this product as a toy. Children under 14 years of age should use it under adult supervision.
2. This product is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience or knowledge, unless they are safely supervised or have been instructed by a person responsible for their safety.
3. Do not blow directly on the human body for extended periods, especially for the elderly and children, to avoid physical discomfort.
4. When using, do not insert fingers, sharp objects, or metal objects that could cause product failure, electric shock risk, or injury.
5. Do not use with wet hands, wet towels, or other damp items to avoid electric shock.
6. This product is not waterproof. Do not use water to rinse the product directly, or use it in bathrooms, areas with high humidity, or water storage areas. Promptly dry any surface water before attempting to turn it on. Do not use if it has been soaked internally or externally.
7. Do not cover the air outlet and inlet, such as with hanging towels, garments, or other objects, to prevent product malfunction.
8. Avoid using and storing in environments with high temperatures (above 60°C) or in enclosed spaces like greenhouses, car interiors, or near fireplaces, as this can cause plastic deformation, fire hazards, battery explosion, and other malfunctions or accidents.
9. Do not crush, disassemble, or place the battery in high-temperature environments (60°C or above) for extended periods, as this poses a risk of liquid leakage or explosion.
10. If consumers use a power adapter for charging, the adapter's input rated voltage and current should be within 5.0V/2.0A and must have met mandatory national safety certifications before use.
11. This product uses a lithium-ion battery and does not have a memory function. Overcharging or over-discharging will affect the product's lifespan. Charge promptly and disconnect the power after full charging. If not used for more than 3 months, please fully charge it.
12. If smoke, fire, or other malfunctions occur during use, immediately turn off the power to stop using the device and send it to the seller or manufacturer for handling. Do not disassemble it to avoid danger.
13. During charging, do not bend or pull the power cable to prevent poor contact.

Specifications

Package Contents

• Handheld Fan Life7 * 1
• USB-C Charging Cable * 1
• Lanyard * 1
• User Manual * 1

Supplier/Distributor Information

Sunnysoft s.r.o.
Kovanecká 2390/1a
190 00 Praha 9
Czech Republic
Website: www.sunnysoft.cz

Note: The content of this manual and product specifications are subject to change without prior notice.