SINOTIMER SVP719 User Manual
Model: SVP719
Your guide to understanding and operating the SINOTIMER SVP719 Voltage Protector and Energy Meter.
Introduction
The SINOTIMER SVP719 is a versatile electrical device designed to protect your electrical systems from common power issues such as overvoltage, undervoltage, and overcurrent. It also functions as an energy meter, allowing you to monitor power consumption in Watts (W) and Kilowatt-hours (kWh).
Key Features
- Adjustable Voltage Protection: Set custom upper and lower voltage limits to safeguard appliances.
- Overcurrent Protection: Prevents damage from excessive current flow.
- Surge Protection: Guards against sudden voltage spikes.
- Energy Metering: Accurately measures real-time power (W) and accumulated energy consumption (kWh).
- High Current Capacity: Rated for up to 63A.
- Wide Voltage Range: Operates with 220V/230VAC power supplies.
- Digital Display: Clear display of voltage, current, power, and energy values.
Specifications
| Parameter | Value |
|---|---|
| Model | SVP719 |
| Brand | SINOTIMER |
| Rated Voltage | 220V / 230VAC |
| Rated Current | 63A |
| Overvoltage Protection Setting Range | 230V - 300V (Adjustable) |
| Undervoltage Protection Setting Range | 160V - 210V (Adjustable) |
| Overcurrent Protection Setting Range | 1A - 63A (Adjustable) |
| Power Measurement | W (Watts) |
| Energy Measurement | kWh (Kilowatt-hours) |
| Operating Temperature | -25°C to +55°C |
Operation
The SVP719 features intuitive controls for setting protection parameters and viewing measurements. Refer to the detailed instructions within the full manual for specific button sequences and display interpretations.
Basic Navigation:
- Press the 'UP' button ⬆️ to increase values or navigate menus.
- Press the 'DOWN' button ⬇️ to decrease values or navigate menus.
- Press the 'SET' button ⚙️ to enter setting mode or confirm a selection.
Setting Voltage Protection:
- Press and hold the 'SET' button ⚙️ for 3 seconds to enter the setting menu.
- Use the 'UP' ⬆️ and 'DOWN' ⬇️ buttons to select the Overvoltage Protection (OVP) setting.
- Press 'SET' ⚙️ again to adjust the OVP value. Use 'UP' ⬆️ and 'DOWN' ⬇️ to set the desired voltage threshold.
- Press 'SET' ⚙️ to confirm the OVP value.
- Repeat steps 2-4 for Undervoltage Protection (UVP) and Overcurrent Protection (OCP) settings.
- The device will automatically save settings and exit the menu after a period of inactivity or upon pressing 'SET' ⚙️ on the final parameter.
Viewing Measurements:
The primary display cycles through Voltage (V), Current (A), Power (W), and Energy (kWh). Pressing the 'UP' ⬆️ or 'DOWN' ⬇️ button briefly can manually cycle through these readings.
Safety Precautions
- Ensure the device is installed by a qualified electrician.
- Always disconnect power before performing any installation or maintenance.
- Verify that the power supply voltage matches the device's rated voltage (220V/230VAC).
- Do not exceed the maximum rated current of 63A.
- Keep the device away from moisture and extreme temperatures.
- This device is intended for indoor use only.
Troubleshooting
If the device trips due to overvoltage, undervoltage, or overcurrent, check the power supply stability and the connected load. Reset the device after the fault condition has been resolved.
For specific error codes or persistent issues, consult the full product documentation or contact SINOTIMER support.
