Important Safety Information & Installation Guidelines
⚠️ Always shut off power to the circuit before starting any installation work.
In some countries, electrical installation work must be carried out by an authorized electrical contractor. Contact your local electricity authority for advice.
⚠️ If the external flexible cable or cord of this luminaire is damaged, it must be exclusively replaced by the manufacturer, their service agent, or a similar qualified person to avoid a hazard. If you are uncertain, please contact IKEA.
⚠️ Do not overtighten connections or screws.
❌ Do not decorate the fixture with garlands.
❓ If you are unsure about any part of the installation, please contact IKEA for assistance.
Parts Included
- Mounting bracket assembly (1x)
- Hex key (1x)
- Lamp shade components (3x)
- Screws (3+3x)
Assembly Instructions
Step 1: Prepare the Main Ring
Attach the three suspension wires to the main circular ring. Ensure the threaded parts are securely screwed into the designated points on the ring.
Step 2: Secure Suspension Wires
Use the provided hex key to tighten the screws that secure the suspension wires to the main ring.
Step 3: Connect Main Power to Canopy
Take the ceiling canopy. Connect the main power supply wires from your ceiling to the appropriate terminals within the canopy's connector block. Ensure correct polarity (L/N).
Step 4: Secure Wiring Connections
Insert the main power cable into the connector mechanism within the canopy and secure it. Ensure all wires are fully inserted into their respective terminals and that the connection clicks into place.
Step 5: Hang the Fixture
With assistance, carefully lift and hang the main fixture assembly from the ceiling support hook. Ensure the suspension point on the fixture is correctly engaged with the ceiling hook. The distance from the ceiling to the attachment point should be between 20-40 mm (3/4" - 1 1/2").
ℹ️ Ensure you are using appropriate electrical cables for connection, such as 2 x 0.75 mm² H03VV-F or 2 x 0.75 mm² H03VVH2-F.
Step 6: Attach Ceiling Canopy
Carefully slide the ceiling canopy upwards to cover the wiring and the connector block. Secure the canopy in place. CAUTION: Do not overtighten.
Step 7: Install Lamp Shades
Gently screw the three lamp shades onto their respective bulb holders. CAUTION: Do not overtighten.
