AKTERSPRING

Safety Information

Assembly Instructions

Follow these steps to assemble your AKTERSPRING table lamp.

1. Step 1: Attach Lamp Arm to Base

   [Visual: The lamp arm is being attached to the base. A magnified inset shows a close-up of a screw and nut mechanism being tightened to secure the connection.]

2. Step 2: Route and Connect Wiring

   [Visual: The assembly of the lamp arm continues, with instructions on how to route the power cord. A magnified inset shows the details of connecting the wires.]

3. Step 3: Attach Lampshade Support

   [Visual: The support arm for the lampshade is being attached. An information icon ⓘ is displayed next to a diagram showing packaging being placed into a recycling bin ♻️, indicating proper disposal.]

4. Step 4: Mount the Lampshade

   [Visual: A warning icon ⚠️ is shown next to an illustration of a cracked lampshade, emphasizing caution. The lampshade is then attached to the arm, with an audible cue indicated as '[click]'.]

5. Step 5: Adjust Lampshade Orientation

   [Visual: A person is depicted holding the assembled lamp and rotating the lampshade to achieve the desired angle or position.]

6. Step 6: Install Light Bulbs

   [Visual: The lamp is shown with dashed lines indicating the internal sockets for light bulbs within the shade. Arrows demonstrate the correct way to screw the bulbs into place.]

7. Step 7: Power On

   [Visual: An information icon ⓘ is presented alongside icons representing a lightbulb ?, an arrow ➡️, and a lit lightbulb, signifying the final step. A hand is shown operating the power switch located on the lamp's base.]