Whirlpool Refrigerator Quick Start Guide

Introduction

Read the Instructions for Use carefully before using the appliance.

Appliance Components

The following components are part of the appliance:

• Control panel
• Main LED 's lighting*
• Fan
• Optional lighting in Multi-flow*
• Shelf divider*
• Multi-flow cold air area*
• Bottle rack *
• Sensor cover
• Zero degrees drawer*
• Rating plate with commercial name
• Cooler compartment (best for meat and fish)*
• Area shelves
• Fruits and vegetables crisper
• Crisper divider*
• Door reversibility kit*
• Egg tray*
• Bottle separator*
• Door trays
• Door seal

* Available on selected models

How to Start the Appliance

After plugging the appliance to the mains, it starts the operation automatically. After starting the appliance, wait at least 4-6 hours before placing food into the appliance. When the appliance is connected to the power supply, the display lights up and all the icons appear on the display for approximately 1 second. The default (factory) values of the fridge compartment settings light-up.

How to Reverse the Door Swing

Consult the enclosed Instructions for Use (Version_2) for details on reversing the door swing. It is recommended that two persons perform this operation. Door reversibility is not foreseen for models with an integrated handle or models with a glass panel on the door.

Key Functions and Controls

6th Sense Fresh Control

This function automatically works to ensure the optimal conditions to preserve the stored food. To deactivate the "6th Sense Fresh Control", press and hold the Fast Cool and Stop Alarm buttons simultaneously for 3 seconds until an audible signal sounds and the “6th Sense Fresh Control" icon turns off, confirming deactivation. Reactivate by repeating the same procedure. Note: Deactivating this function also switches off the FAN in the fridge.

ON/STANDBY

To put the product in Stand-by mode, press and hold the button for 3 seconds. All icons turn off except the On/Standby indicator. To reactivate the appliance, press this button briefly.

FAN

The Fan improves temperature distribution inside the product, allowing better preservation of stored food. By default, the fan is switched on. To switch off the FAN, press and hold the Fast Cool and Stop Alarm buttons simultaneously for 3 seconds until an audible signal sounds and the “6th Sense Fresh Control" icon turns off, confirming the fan has been switched off. To switch on the FAN, repeat the same procedure. An audible signal sounds and the icon turns on as confirmation. Note: For reasons why to switch off the fan, refer to "ENERGY-SAVING TIPS" in the Instructions for Use.

VACATION button

This function can be activated to reduce the appliance's energy consumption during prolonged periods of time. Before activating, remove all perishable food and ensure the door is properly closed, as the refrigerator will maintain a suitable temperature to prevent unpleasant odors (+12°C). To activate/deactivate, press the Vacation mode button for 3 seconds. When enabled, the related symbol lights up, and the refrigerator compartment temperature will be set to a higher setpoint (the temperature display will show +12°C). Changing the temperature setpoint automatically deactivates the function.

TEMPERATURE button

Press the temperature button to change the temperature. The value cycles between 8°C and 2°C. Note: Displayed set points correspond to the average temperature throughout the whole refrigerator.

FAST COOL button

Using the Fast Cool function, you can increase the cooling capacity in the refrigerator compartment. This function is recommended when placing a very high quantity of food inside. Press the Fast Cool button to activate it. The Fast Cool indicator turns on when activated. The function automatically disables after 6 hours, or can be manually disabled by pressing the Fast Cool button again.

ALARM indicator

Refer to the Alarms Table below.

STOP ALARM button

Press this button in case of an alarm to mute the acoustic alarm.

Alarms Table