JOKKMOKK Chair
Important Assembly Note
Make sure that you tighten the screws well. For increased stability, re-tighten the screws about two weeks after assembly.
Parts Included
- Screw (Part 104322): 6 pieces
- Dowel/Connector (Part 101350): 20 pieces
- Allen Key (Part 100092): 1 piece
- Screw (Part 122925): 4 pieces
- Foot/Base (Part 122620): 4 pieces
Assembly Steps
Step 1
Attach the four Foot/Base parts (122620) to the underside of the seat base. The diagram shows these being secured, implying screws are used.
Step 2
Connect the side frame pieces to the seat base. This step uses 20 Dowel/Connectors (101350) and screws, as indicated by the diagram showing multiple connection points.
Step 3
Attach the back legs/supports to the seat base. Use three Screws (104322) and the Allen Key (100092) for this step. The diagram shows the screws being inserted into pre-drilled holes.
Step 4
Flip the partially assembled chair. Attach the backrest supports to the seat base using three Screws (104322) and the Allen Key (100092). The diagram shows the chair being turned over and screws being inserted.
Step 5
Place the seat onto the assembled frame. A person is shown guiding the seat into position.
Step 6
The assembled frame is shown. A close-up diagram indicates alignment or adjustment of parts.
Step 7
Secure the chair by attaching the four Screws (122925). The diagram shows these screws being inserted into the Foot/Base parts (122620) to finalize the assembly.