Weaxty Patio Umbrella Assembly Instructions
Contact: SaraHalton45@outlook.com
Parts List
| Part Number | Description | QTY | Part Number | Description | QTY |
|---|---|---|---|---|---|
| A | Cross Bar Support | 1 | J | Base Cover | 1 |
| B | Bottom Cross Base | 1 | K | Sand Bag | 2 |
| C | Topcross Base | 1 | L | Umbrella Body | 1 |
| D | Screw (M8×16) | 2 | M | Lower Pole | 1 |
| E | Screw (M8×40) | 2 | N | Solar Panel | 1 |
| F | Washer | 4 | O | Middle Light | 2 |
| G | Foot Tube | 1 | P | Remote Control | 1 |
| H | Fence Torer | 4 | |||
| I | Fence Body | 4 |
Assembly Steps
-
Step 1
Place part A (Cross Bar Support) into part B (Bottom Cross Base), then tighten the screws (D and F).
[Diagram: Shows parts A, B, C, D, E, F, G being assembled. Part A is inserted into Part B, and screws D and F with washers F are used to secure it. Part C is also shown.
-
Step 2
Attach parts H (Fence Torer) to the base structure. Arrows indicate the direction of attachment.
[Diagram: Shows the base structure with four parts H being attached, indicated by arrows pointing inwards.]
-
Step 3
Attach parts I (Fence Body) to the base structure. Arrows indicate the direction of attachment.
[Diagram: Shows the base structure with four parts I being attached, indicated by arrows pointing inwards.]
-
Step 4
Fill two K (Sand Bags) with sand. Place them on the cross metal base, and then put on J (Base Cover).
[Diagram: Shows two bags K being filled with sand and placed onto the base, followed by placing the base cover J on top.]
-
Step 5
1. Connect the solar panel wires properly. 2. Rotate part N (Solar Panel) clockwise to secure it. 3. Align part L (Umbrella Body) with part M (Lower Pole) and rotate clockwise to fix it in place.
[Diagram: Illustrates connecting wires, securing the solar panel N, and attaching the umbrella body L to the lower pole M with a clockwise rotation.]
-
Step 6
Align the umbrella pole with the base tube and install it. Finally, fasten the base bag buckle.
[Diagram: Shows the umbrella pole being inserted into the base and a buckle being fastened.]
-
Step 7
Turn the handle clockwise to open the umbrella; turn counterclockwise to close it.
[Diagram: Shows a handle with a circular arrow indicating clockwise rotation to open and counterclockwise to close.]
-
Step 8
Secure the locking pin.
[Diagram: Close-up view showing a locking pin being secured.]
-
Step 9
Plug in the middle light wire, then rotate it clockwise. Done!
[Diagram: Shows connecting a wire for the middle light and rotating it clockwise. A remote control P is also shown, with text indicating it can adjust lighting modes.]
Remote Control Functions
The remote control (P) can adjust the lighting modes. Functions include:
- Speed - / Brightness -
- Speed + / Brightness +
- OFF / ON buttons
- Color selection: R (Red), G (Green), B (Blue), W (White)
- Mode selection:
- FLASH: Automatic Mode Cycle
- STROBE: Rainbow Jumping Border
- FADE: Rainbow Strobe
- SMOOTH: Rainbow Gradient
[Diagram: A detailed layout of the remote control buttons with labels for color selection, mode selection, and brightness/speed adjustments.]
