Weaxty Patio Umbrella Assembly Instructions
Contact: SaraHalton45@outlook.com
Parts List
| Part Number | Description | QTY | Part Number | Description | QTY |
|---|---|---|---|---|---|
| A | Cross Bar Support | 1 | J | Base Cover | 1 |
| B | Bottom Cross Base | 1 | K | Sand Bag | 2 |
| C | Topcross Base | 1 | L | Umbrella Body | 1 |
| D | Screw (M8×16) | 2 | M | Lower Pole | 1 |
| E | Screw (M8×40) | 2 | N | Disassembled Rib | 12 |
| F | Washer | 4 | O | Solar Panel | 1 |
| G | Foot Tube | 1 | P | Middle Light | 2 |
| H | Fence Corer | 4 | |||
| I | Fence Body | 4 |
Assembly Steps
Step 1
Place part A (Cross Bar Support) into part B (Bottom Cross Base), then tighten the screws (D and E) with washers (F).
Step 2
Attach part H (Fence Corer) to the base structure, securing them with the fence body parts (I).
Step 3
Continue assembling the base structure by attaching the remaining fence body parts (I) and ensuring all connections are secure.
Step 4
Fill the sand bags (K) with sand and place them onto the cross base. Then, place the base cover (J) over the cross base.
Step 5
Connect the solar panel wires properly. Rotate the solar panel (O) clockwise to secure it. Align the umbrella body (L) with the lower pole (M) and rotate clockwise to fix it in place.
Step 6
First, install the ribs (N). Align the disassembled ribs with the inner ribs and snap them into place. Insert the installed ribs into the umbrella fabric. Align the umbrella pole with the base tube and install it. Finally, fasten the base bag buckle.
Step 7
Turn the handle clockwise to open the umbrella and counterclockwise to close it.
Step 8
Secure the locking pin to keep the umbrella in the desired position.
Step 9
Plug in the middle light wires (P). Rotate the light strip control switch clockwise. Done!
