SHADA Solar LED Garden Torch
Model: 1000428
OUTDOOR SERIES
Product Overview
The SHADA Solar LED Garden Torch is designed for outdoor illumination. It automatically activates at dusk, powered by a solar panel that charges an internal battery during daylight hours. The brightness and duration of the light are dependent on the amount of solar energy absorbed.
Specifications
| Specification | Details |
|---|---|
| Power | 1.7W |
| Battery Type | 3.7V - 2,200mAh - 8.14 Wh (Ni-Mh / Li-ion) |
| Luminous Flux | 65lm |
| Colour Temperature | 2,200K |
| LED Lifetime | 20,000 hours |
| Beam Angle | 360° |
| Dimensions | 600mm (Height) x 120mm (Diameter) |
| Degree of Protection | IP44 |
Installation and Operation
Ideal Positioning
To ensure optimal performance, place the solar torch in a location that receives direct sunlight for at least 8 hours daily. Avoid shaded areas or spots near other light sources (e.g., streetlights) that might interfere with the dusk sensor.
Assembly and First Use
Follow these steps for assembly and initial operation:
- Carefully unpack all components.
- Assemble the lamp housing according to the diagrams (refer to Figure 1 on page 2). The torch can be mounted using either a wall mount option or a ground mount option, typically requiring three screws for each. The assembled torch measures 600 mm in height and 120 mm in diameter.
- Press the ON/OFF switch [*] once to turn the lamp on (refer to Figure 2 on page 2).
Troubleshooting
If the solar lamp does not automatically turn on at dusk, please check the following:
- Battery Not Charged: Ensure the lamp is positioned in an optimal location with sufficient direct sunlight for charging. In conditions of insufficient light (e.g., overcast skies or poor weather), the lamp will resume normal operation on the next sunny day.
- Proximity to Light Sources: The lamp may be too close to streetlights or other strong external light sources. Relocate the lamp to a darker area, away from interfering lights.
- Insufficient Direct Sunlight: Verify that the lamp is not placed in a shaded area, such as next to a building or under a tree. Move it to a location with unobstructed direct sunlight.
- Switch Position: Ensure the ON/OFF switch is in the "ON" position. You can test the lamp's functionality by taking it into a completely dark room.
Attention and Safety Information
Winter Use
Due to the battery type, this product is not recommended for winter use. To prevent deep discharge of the Lithium-Ion battery during winter, it is advised to store the fully charged lamp in a deactivated state in a frost-free environment. Deep discharge of the battery is not covered by warranty.
Battery Disposal
Used batteries should not be disposed of with household waste. As an end-user, you are responsible for recycling used batteries or taking them to designated collection points (e.g., household hazardous waste facilities, authorized recyclers). Never dispose of batteries in fire. Use only batteries of the same type and specifications as the original. Do not mix old and new batteries.
General Safety
- Read the manual carefully before use and keep it for future reference.
- Use the product only for its intended purpose.
- Do not use the product if any part is damaged or defective. Replace immediately if damaged.
- Keep out of reach of children.
- Do not modify the product.
- Do not expose the product to water or moisture. (IP44 rating indicates protection against solid objects larger than 1mm and splashing water, but not immersion).
- Keep the product away from heat sources.
- Do not block ventilation openings.
- Do not look directly at the LED lamp.
- Maintain a minimum distance of 2 meters between the lamp and the illuminated surface.
Electrical Safety
- To reduce the risk of electric shock, the product should only be opened by an authorized technician for repairs.
- Do not use the product if the cable or plug is damaged. It must be replaced by the manufacturer or an authorized service center.
- Ensure the voltage matches the device's rating plate.
- Ensure the cable does not hang over edges where it can be caught or cause tripping.
Light Source Warning
The light source contained in this luminaire shall only be replaced by the manufacturer or their service agent or a similarly qualified person.
Caution: Risk of electric shock.
The external cable or flexible cord of this luminaire cannot be replaced; if the cord is damaged, the luminaire shall be destroyed.
Legal and Compliance
Designs and specifications are subject to change without prior notice. All logos, brands, and product names are trademarks or registered trademarks of their respective holders.
Visit www.shada.nl for more information.
This product complies with relevant EU directives:
- EMC: 2014/30/EU
- RoHS: 2011/65/EU
The Declaration of Conformity (DoC) can be downloaded from the provided link.
