Delta Two Handle Widespread Bathroom Faucets

Product Information

Model Number: 107687

For replacement parts and additional technical documents, visit: www.deltafaucet.com

Customer Service: customerservice@deltafaucet.com | 1-800-345-3358

Important Safety Information

CAUTION: Failure to read these instructions prior to installation may result in personal injury, property damage, or product failure. Manufacturer assumes no responsibility for product failure due to improper installation.

Installation Instructions

Step 1: Shut Off Water Supplies

Turn off hot and cold water supplies. Remove the old faucet. Slide the hot and cold end valves (1) with gaskets (2) through the sink mounting holes. If the sink is uneven, use silicone under the gaskets. Ensure long tubes (3) are installed away from the spout and handle. The side with the label for HOT WATER should be on the left. Secure the end valves with washers (4) and threaded brackets (5). Hand-tighten the brackets (5) onto the shank (6). Lock the brackets into position by tightening screws (7).

Step 2: Install Spout

Place the spout (1) with gasket (2) through the sink mounting hole. Secure the spout and gasket with bracket (3) and nut (3). Use a Phillips screwdriver to rotate the wrench (4) if the faucet is not tight enough. If the sink is uneven, use silicone under the gasket.

Step 3: Connect Quick Connects

Push the quick connects (1) firmly upward and snap them onto the tubes (2). Pull down moderately to ensure each connection has been made.

Step 4: Connect to Water Supplies

(HOOK-UPS NOT PROVIDED)

Turn on hot and cold water supplies and flush water lines into a container for one minute. This flushes away any debris that could cause damage to internal parts.

Choose hook-ups for 1/2" I.P.S. connections: (1) Ball nose riser (3/8" O.D. copper tubing), or (2) 1/2" I.P.S. faucet connector. Use coupling nuts (3) (not supplied) with the ball nose risers (1). Use two wrenches when tightening. Do not overtighten.

Step 5: Install Pop-Up Assembly

A. Remove stopper (1) and flange (2). Screw nut (3) all the way down. Push black gasket (4) down.

B. Apply silicone to the underside of the flange (1). Insert body (2) into the sink. Screw the flange onto the body. The pivot hole (3) must face the back of the sink. Pull the assembly down firmly and hold in place. DO NOT TWIST. Tighten nut (4) and remove excess sealant.

C. Remove pivot nut (1). Install horizontal rod (2) and stopper (3) as removable (4) or non-removable (5). Hand tighten nut (1). Gaskets (6) are only required if supplied.

D. Attach horizontal rod (1) to strap (2) using clip (3). Install lift rod (4), tighten screw (5). Connect assembly to drain (6).

Step 6: Flush System and Check for Leaks

Remove aerator (1) using supplied wrench (2) or coin and turn faucet handles (3) to the full on mixed position. Turn on hot and cold water supplies (4) and flush water lines for one minute.

Important: This flushes away any debris that could cause damage to internal parts.

Check all connections at arrows for leaks. Re-tighten if necessary, but do not overtighten. Replace aerator.

Maintenance

Shut Off Water Supplies

NOTE: Remove handles by turning the handle base counterclockwise.

If faucet exhibits very low flow:

• Replace Stem Unit Assembly (1) and Seats and Springs (2)*.
• A. Remove and clean Aerator (3), or
• B. Clean Seats and Springs (2) of any debris.

*Install stems (1) correctly for proper handle rotation:

1. The stops (4) must point to the center of the faucet for proper handle rotation.

2. Replace handle properly. Be sure the handle with "H" mark (5) is installed onto the left and the handle with "C" mark onto the right.

Limited Warranty

Parts and Finish: Delta® faucets are warranted to the original consumer purchaser to be free from defects in material and workmanship for as long as the original consumer purchaser owns the home in which the faucet was first installed. For commercial purchasers, the warranty period is ten (10) years for multi-family residential applications and five (5) years for all other commercial applications.

Electronic Parts: Electronic parts (other than batteries) are warranted to the original consumer purchaser to be free from defects in material and workmanship for five (5) years from the date of original purchase. No warranty is provided on batteries.

What We Will Do: Delta Faucet Company will repair or replace, free of charge, any part or finish that proves defective in material and/or workmanship under normal installation, use and service. If repair or replacement is not practical, Delta Faucet Company may elect to refund the purchase price in exchange for the return of the product.

What Is Not Covered: This warranty does not cover Delta products purchased from unauthorized sellers. Labor charges incurred by the purchaser to repair, replace, install or remove this product are not covered. Delta Faucet Company shall not be liable for any damage to the faucet resulting from reasonable wear and tear, outdoor use, misuse, freezing water, abuse, neglect or improper or incorrectly performed installation, maintenance or repair, including failure to follow the applicable care and cleaning instructions.

What You Must Do To Obtain Warranty Service or Replacement Parts: Call 1-800-345-DELTA (3358) or contact Delta Faucet Company by mail or online at www.deltafaucet.com/service-parts/contact-us. Proof of purchase (original sales receipt) is required unless the product has been registered or is a Delta® Recertified product purchased from deltafaucet.com.

This warranty applies only to Delta® faucets manufactured after January 1, 2019 and installed in the United States of America, Canada and Mexico.

Limitation on Duration of Implied Warranties: Implied warranties, including the implied warranties of MERCHANTABILITY and FITNESS FOR A PARTICULAR PURPOSE, are limited to the statutory period or the duration of this warranty, whichever is shorter.

Limitation of Special, Incidental or Consequential Damages: This warranty does not cover, and DELTA FAUCET COMPANY SHALL NOT BE LIABLE FOR, ANY SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES (INCLUDING LABOR CHARGES TO REPAIR, REPLACE, INSTALL OR REMOVE THIS PRODUCT), WHETHER ARISING OUT OF BREACH OF ANY EXPRESS OR IMPLIED WARRANTY, BREACH OF CONTRACT, TORT, OR OTHERWISE.

This warranty gives you specific legal rights, and you may also have other rights which vary from state/province to state/province.

© 2020 Delta Faucet Company