STOCKHOLM 2025 Floor Lamp
By IKEA
Important Safety and Usage Information
⚠️ For indoor use only.
Warning: The external flexible cable or cord of this luminaire cannot be replaced. If the cord is damaged, the luminaire must be destroyed.
Parts Included
- 1x Lamp pole (long cylindrical section)
- 1x Base (square piece)
- 3x Small circular fasteners/caps
Tools required: Screwdriver (?). If you encounter difficulties, seek assistance from IKEA.
Assembly Steps
Step 1: Prepare the Top Assembly
Attach the electrical component (socket holder) to the top of the main lamp pole. This involves screwing the component onto the pole.
Step 2: Route the Power Cord
Feed the power cord down through the lamp pole and out through the base. Ensure the cord is routed correctly to avoid damage. ❌ Avoid improper routing as indicated in the diagrams.
Step 3: Connect Pole Sections
Connect the next section of the lamp pole to the existing assembly. This is done by screwing the threaded ends of the pole sections together. ❌ Ensure correct alignment to avoid damage.
Step 4: Secure Pole to Base
Attach the assembled lamp pole to the base. Use screws to fasten the pole securely to the base.
Step 5: Cable Management
Attach one of the small circular fasteners to the base, likely to secure or manage the power cord.
Step 6: Connect Final Pole Section
Connect the remaining section of the lamp pole to the assembly, following the same method as Step 3.
Step 7: Attach Lampshade
Carefully lower the lampshade onto the top assembly. Align it with the fixture and prepare to secure it.
Step 8: Install Light Bulbs
Insert three (3x) light bulbs into the sockets within the lampshade assembly. ?
Step 9: Secure Lampshade
Use the provided screws (3x) to fasten the lampshade securely to the lamp fixture. ?
Step 10: Final Check and Operation
Ensure all connections are secure. The lamp is now ready for use. The diagram shows the lamp lit and a close-up of a rotating mechanism, possibly for final adjustments.
