HOMCOM Adjustable Stool

Important Information

IMPORTANT: RETAIN FOR FUTURE REFERENCE: READ CAREFULLY.

This product is intended for domestic use only.

Instructions for Use:

• Place the stool stably on a flat floor.
• Keep away from open flames and heat sources.
• Avoid overloading the stool.

Precautions Before Assembly:

• Prepare a clean and dry mounting area.
• Verify that the product is not damaged.
• Check that all parts are present.

Maintenance:

• Clean with a soft fabric.
• Regularly check the seating.

Storage Conditions:

• The fabric should be stored completely dry, in a clean and dry place to avoid the risks of mold.

Safety Warnings

Be aware of crushing and cutting hazards during assembly.

The manufacturer declines all responsibility in case of damages due to a bad installation or environmental factors.

⚠️ Warning! Replacement and repair of components for height adjustment of seating furniture with energy storage must be performed only by qualified personnel.

If the product has electrical parts:

• This appliance can be used by children aged 8 years and above, and persons with reduced physical, sensory, or mental capabilities or lack of experience and knowledge, if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not be made by children without supervision.
• The appliance is only to be used with the power supply unit provided with the appliance.
• The external flexible cable or cord of this transformer cannot be replaced; if the cord is damaged, the transformer shall be scrapped. [Warning: Damaged power supply unit or cable] ⚠️
• If the appliance has a heated surface, persons insensitive to heat must be careful when using the appliance.
• The power supply unit shall not be used if the pins of the plug part are damaged.

Parts and Hardware

Parts:

Hardware:

Assembly Instructions

Step 01: Prepare the Base

Attach the five casters (A) to the five sockets on the base (B). Insert the gas lift cylinder (D) into the central opening of the base (B).

[Diagram Description: Shows casters being pushed into the base legs, and the gas lift cylinder being inserted into the center of the base.]

Step 02: Attach Seat Mechanism

Align the seat mechanism (E) with the pre-drilled holes on the underside of the seat (C). Secure the mechanism using four screws (F) and four washers (H) and four washers (I). Tighten with the provided Allen wrench (G).

[Diagram Description: Shows the seat mechanism being placed on the seat, with screws and washers inserted and tightened.]

Step 03: Complete Assembly

Place the assembled seat (C with E) onto the top of the gas lift cylinder (D). Ensure it is securely seated.

[Diagram Description: Shows the seat assembly being lowered onto the gas lift cylinder.]