DETOLF Glass-Door Display Cabinet

Important Safety Information

WARNING! Serious or fatal crushing injuries can occur from furniture tip over. To prevent tip over, this furniture must be used with the wall attachment device(s) provided.

Screws and wall plugs are not included. Use screws and plugs suitable for your walls. If you are uncertain, seek professional advice. Read and follow each step of the instructions carefully.

Assembly Instructions

1. Attach two L-shaped brackets (part 109049) to the base panel using two screws (part 100823) and two nuts (part 100823).

2. Attach one L-shaped bracket (part 106989) to the top panel using one screw (part 100823) and one nut (part 100823).

3. Attach the four feet (part 101649) to the base panel using four screws (part 106989).

4. Insert the two side panels into the base, aligning them with the slots.

5. Place the top panel onto the side panels.

6. Secure the side panels to the top and base panels using two cam locks (part 113290) and two screws (part 100600) for each connection point.

7. Insert the four glass shelves (part 102039) into the pre-drilled holes on the side panels.

8. Attach the back panel support (part 109562) to the top and base panels using two screws (part 100823) and two nuts (part 100823).

9. Attach the top back panel (part 10004736) to the top panel using one screw (part 100002).

10. Attach four door hinges (part 109842) to the cabinet frame using four screws (part 100600).

11. Attach two door hinges (part 101649) to each glass door using two screws (part 100002).

12. Connect the glass doors to the cabinet frame by attaching the hinges to the corresponding mounting points.

13. Secure the door hinges.

14. Attach the two door handles (part 102047) to the glass doors using two screws (part 101649) for each handle.

15. Attach the top decorative strip (part 10004736) to the top panel using one screw (part 100600).

16. Attach the bottom decorative strip to the base panel using one screw (part 101649).

17. Slide the back panel into the grooves on the side, top, and bottom panels.

18. Attach the glass doors to the cabinet frame.

19. Secure the glass doors using the provided fittings.

20. Perform a final check of the assembled cabinet.

21. IMPORTANT: Secure the cabinet to the wall using appropriate wall attachment devices suitable for your wall type. This is crucial to prevent tip-over accidents.