Redmi Note 10 5G Quick Start Guide

Introduction

Thank you for choosing the Redmi Note 10 5G. To turn on the device, long press the power button. Follow the on-screen instructions to configure your device. For more detailed information, please visit the official website: www.mi.com/global/service/userguide.

MIUI

The Redmi Note 10 5G comes pre-installed with MIUI, Xiaomi's customized Android-based operating system. MIUI offers frequent updates and user-friendly features, developed based on feedback from over 200 million active users worldwide. For more information, visit en.miui.com.

Device Overview

The device features a touchscreen display. On the right side, you will find the Volume Buttons and the Power Button. The bottom of the device has a USB Type-C Port.

SIM Card Tray

The SIM card tray supports Dual SIM cards with no carrier restrictions and dual 5G connectivity. It features two Nano-SIM card slots, either of which can be set as the primary card. The device also supports Dual SIM 5G/4G/3G/2G and Dual SIM VoLTE. Please ensure you use standard Nano-SIM cards. Inserting non-standard SIM cards may damage the SIM card slot.

Note: 5G connection availability depends on your country, carrier, and user environment. VoLTE availability depends on the carrier's network and service deployment.

WARNING: Do not disassemble this device.

WEEE Disposal Information

Special precautions must be taken for the safe disposal of this product. The WEEE (Waste Electrical and Electronic Equipment) marking indicates that this product should not be discarded with other household waste within the EU. To prevent harm to the environment or human health from improper waste disposal, and to promote the sustainable reuse of material resources, please recycle responsibly. To safely recycle your device, use return and collection systems or contact the retailer where the device was originally purchased. For the Environmental Declaration, visit www.mi.com/en/about/environment.

Important Safety Information

Read all safety information below before using your device:

• Use only authorized cables, power adapters, and batteries compatible with your device. Unauthorized accessories can cause fire, explosion, or other risks.
• The device's operating temperature range is 0°C to 40°C. Using the device outside this range may cause damage.
• If your device has a built-in battery, do not attempt to replace it yourself to avoid damaging the battery or device.
• Charge the device only with the included or authorized cable and power adapter. Using other adapters may cause fire, electric shock, or damage.
• After charging, disconnect the adapter from the device and the power outlet. Do not charge for more than 12 hours.
• Batteries must be recycled or disposed of separately from household waste. Mishandling batteries can cause fire or explosion. Dispose of or recycle the device, its battery, and accessories according to local regulations.
• Do not disassemble, hit, crush, or burn the battery. Stop using immediately if the battery appears deformed or damaged.
• Do not short-circuit the battery, as this may cause overheating, burns, or other injury.
• Do not place the battery in high-temperature environments, as overheating may cause explosion.
• Do not disassemble, hit, or crush the battery, as this may cause it to leak, overheat, or explode.
• Do not burn the battery, as this may cause fire or explosion.
• If the battery appears deformed or damaged, stop using it immediately.
• Battery removal or repair should only be performed by an authorized repair center.
• Keep your device dry.
• Do not attempt to repair the device yourself. Contact customer support or an authorized repair center if any part malfunctions.
• Connect other devices according to their manuals. Do not connect incompatible devices.
• For AC/DC adapters, the socket-outlet should be installed near the equipment and be easily accessible.

Safety Precautions

• Observe all applicable laws and rules restricting mobile phone use in specific situations and environments.
• Do not use your phone at petrol stations, in explosive atmospheres, or in areas where the air may contain chemicals or particles (e.g., grain, dust, metal powders). Obey posted signs to turn off wireless devices. Turn off your phone in blasting areas or areas requiring "two-way radios" or "electronic devices" to be turned off.
• Do not use your phone in hospital operating rooms, emergency rooms, or intensive care units. Always comply with hospital and health center rules. If you have a medical device, consult your doctor and the manufacturer to determine if your phone may interfere. Maintain a minimum distance of 15 cm between your phone and a pacemaker, using the ear opposite the pacemaker and not carrying the phone in a breast pocket. Avoid using the phone near hearing aids, cochlear implants, or similar devices.
• Observe aircraft safety regulations and turn off your phone on board aircraft when required.
• When driving, use your phone in accordance with traffic laws and regulations.
• To avoid lightning strikes, do not use your phone outdoors during thunderstorms.
• Do not make calls while charging.
• Do not use your phone in high humidity areas like bathrooms, as this may result in electric shock, injury, fire, and charger damage.

Security Statement

Update your phone's operating system using the built-in software update feature or visit an authorized service outlet. Updating via other means may damage the device, cause data loss, or create security issues.

EU Regulations

RED Declaration of Conformity

Xiaomi Communications Co., Ltd. declares that this GSM / GPRS / EDGE / UMTS / LTE / 5G NR Digital Mobile Phone with Bluetooth and Wi-Fi M2103K19G complies with the essential requirements and other relevant provisions of the RE Directive 2014/53/EU. The full text of the EU declaration of conformity is available at: www.mi.com/en/certification.

RF Exposure Information (SAR)

This device complies with Specific Absorption Rate (SAR) limits for general population/uncontrolled exposure (Localized 10-gram SAR for head and trunk, limit: 2.0W/kg) as specified in Council Recommendation 1999/519/EC, ICNIRP Guidelines, and RED (Directive 2014/53/EU). During SAR testing, the device transmitted at its highest certified power level in all tested frequency bands. For head exposure, there was no separation. For body exposure, a separation of 5 mm was maintained.

SAR compliance for body operation is based on a 5 mm separation distance from the human body. The device should be carried at least 5 mm away from the body to ensure RF exposure levels are compliant or lower than reported. When attaching the device near the body, use a belt clip or holster without metallic components that maintains at least 5 mm separation. RF exposure compliance was not tested or certified with any metal-containing accessory worn on the body, and such accessories should be avoided.

Certification Information (Highest SAR)

SAR 10 g limit: 2.0 W/Kg. SAR Value: Head: 0.539 W/Kg, Body: 0.895 W/Kg (5 mm distance).

Legal Information

This device may be operated in all EU member states. Observe national and local regulations. This device is restricted to indoor use only when operating in the 5150 to 5350 MHz frequency range in Hong Kong and the following countries: AT, BE, BG, HR, CY, CZ, DK, EE, FI, FR, DE, EL, HU, IE, IT, LV, LT, LU, MT, NL, PL, PT, RO, SK, SI, ES, SE, UK(NI), IS, LI, NO, CH, TR.

2.4 GHz Band Restrictions: Norway: This subsection does not apply for the geographical area within a 20 km radius from the center of Ny-Ålesund.

Receiver Category 2

Ensure the power adapter used meets the requirements of Clause 6.4.5 in IEC/EN 62368-1 and has been tested and approved according to national or local standards.

Frequency Bands and Power

This mobile phone offers the following frequency bands in EU areas only and maximum radio-frequency power:

• GSM 900: 35.5 dBm
• GSM 1800: 32.5 dBm
• WCDMA 900/2100: 25.7 dBm
• LTE band 1/3/7/8/20/28/38/40: 25.7 dBm
• 5G NR band n1/n3/n7/n8/n20/n28/n38/n40/n41: 26 dBm, 5G NR band n77/n78: 29 dBm
• Bluetooth: 20 dBm
• Wi-Fi 2.4 GHz band: 20 dBm
• Wi-Fi 5 GHz: 5150 to 5250MHz: 23 dBm, 5250 to 5350 MHz: 23 dBm, 5470 to 5725 MHz: 23 dBm, 5725 to 5850 MHz: 14 dBm
• NFC: 13.56 MHz < 42 dBuA/m at 10m

FCC Regulations

This mobile phone complies with Part 15 of the FCC Rules. Operation is subject to two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This mobile phone has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used per instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur. If this equipment causes harmful interference to radio or television reception (which can be determined by turning the equipment off and on), the user is encouraged to try to correct the interference by:

• Reorienting or relocating the receiving antenna.
• Increasing the separation between the equipment and receiver.
• Connecting the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consulting the dealer or an experienced radio/TV technician.

RF Exposure Information (SAR)

This device meets government requirements for radio wave exposure. It is designed and manufactured not to exceed emission limits for radio frequency (RF) energy. The exposure standard for wireless devices uses Specific Absorption Rate (SAR). The FCC SAR limit is 1.6 W/Kg. For body-worn operation, this device has been tested and meets FCC RF exposure guidelines for use with a non-metallic accessory that positions the device at least 1.0 cm from the body. RF exposure compliance with any metal-containing body-worn accessory has not been tested or certified, and such accessories should be avoided. Any accessory used for body-worn operation must keep the device at least 1.0 cm away from the body.

FCC Note

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Shielded cables must be used with this unit to ensure compliance with Class B FCC limits.

UK Regulations

Declaration of Conformity

Xiaomi Communications Co., Ltd. declares that this GSM / GPRS / EDGE / UMTS / LTE / 5G NR Digital Mobile Phone with Bluetooth and Wi-Fi M2103K19G is in compliance with the essential requirements and other relevant provisions of the UK Radio Equipment Regulations 2017 (SI 2017/1206). The full text of the UK declaration of conformity is available at: www.mi.com/en/certification.

RF Exposure Information (SAR)

This device is in compliance with Specific Absorption Rate (SAR) limits for general population/uncontrolled exposure (Localized 10-gram SAR for head and trunk, limit: 2.0W/kg) specified in Council Recommendation 1999/519/EC, ICNIRP Guidelines, and UK Radio Equipment Regulations 2017 (SI 2017/1206). During SAR testing, the device was set to transmit at its highest certified power level in all tested frequency bands and placed in positions that simulate RF exposure during use against the head with no separation and near the body with a separation of 5 mm.

SAR compliance for body operation is based on a separation distance of 5 mm between the unit and the human body. This device should be carried at least 5 mm away from the body to ensure RF exposure level is compliant or lower than the reported level. When attaching the device near the body, a belt clip or holster should be used which does not contain metallic components and allows a separation of at least 5 mm to be maintained between the device and the body. RF exposure compliance was not tested or certified with any accessory containing metal worn on the body, and use of such an accessory should be avoided.

Certification Information (Highest SAR)

SAR 10 g limit: 2.0 W/Kg. SAR Value: Head: 0.539 W/Kg, Body: 0.895 W/Kg (5 mm distance).

E-label

This device has an electronic label for certification information. To access it, go to Settings > About phone > Certification, or open Settings and type "Certification" into the search bar.

Model: M2103K19G. The '2103' indicates that this product will be launched after March 2021.

Adapter

Manufacturer: Xiaomi Communications Co.,Ltd.

Address: #019, 9th Floor, Building 6, 33 Xi'erqi Middle Road, Haidian District, Beijing, China

Model: MDY-11-EN

Input Voltage: 100-240V~

Input Frequency: 50/60Hz

Output Voltage: 5.0V/9.0V/12.0V/10.0V

Output Current: 3.0A/2.23A/1.67A/2.25A Max

Output Power: 15.0W/20.0W/20.0W/22.5W Max

Average Active Efficiency: ≥81.39%

Disclaimer

This user guide is published by Xiaomi or its local affiliated company. Improvements and changes may be made at any time without notice due to typographical errors, inaccuracies, or program/equipment improvements. Such changes will be incorporated into new online editions of the user guide (see www.mi.com/global/service/userguide for details). All illustrations are for illustrative purposes only and may not accurately depict the actual device.

This smartphone is designed with Corning® Gorilla® Glass 3.

Manufacturer: Xiaomi Communications Co., Ltd.

Manufacturer postal address: #019, 9th Floor, Building 6, 33 Xi'erqi Middle Road, Haidian District, Beijing, China, 100085

Brand: Redmi

Model: M2103K19G

© Xiaomi Inc. All rights reserved.