Redmi Note 10 5G Quick Start Guide

Welcome to Redmi Note 10 5G

Press and hold the power button to turn on the device. Follow the on-screen instructions to configure your device. For more information, visit the official website: www.mi.com/global/service/userguide

MIUI

Redmi Note 10 5G comes pre-installed with MIUI, Xiaomi's customized Android-based operating system. MIUI provides frequent updates and user-friendly features based on suggestions from over 200 million active users worldwide. For more information, please visit en.miui.com

Device Overview

The Redmi Note 10 5G features volume buttons and a power button on the side. The USB Type-C port is located at the bottom of the device.

SIM Card Holder

The device supports Nano-SIM cards and a Micro SD card. The SIM card tray has slots for two Nano-SIM cards and one Micro SD card.

About Dual SIM Slots

• Supports dual SIM cards without operator restrictions, dual 5G ①.
• Supports two Nano-SIM card slots, either of which can be set as the primary card.
• Supports dual SIM cards with 5G/4G/3G/2G.
• Supports dual SIM cards with VoLTE ②.

Note ①: 5G connectivity depends on the country, operator, and user environment.

Note ②: VoLTE depends on the operator's network deployment and related service.

• Please do not insert non-standard SIM cards into the SIM card slot. They may damage the SIM card slot.
• WARNING: Do not disassemble this device.

Waste Electrical and Electronic Equipment (WEEE)

Special safety precautions must be taken for the safe disposal of this product. This marking indicates that this product should not be disposed of with other household waste within the EU. To prevent harm to the environment or human health from improper waste disposal and to promote the sustainable reuse of material resources, please recycle responsibly.

For safe recycling of your device, please use return and collection systems or contact the retailer from whom the device was originally purchased.

To view Xiaomi's environmental declaration, please use the following link: www.mi.com/en/about/environment

WARNING

RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO INSTRUCTIONS.

⚠To prevent possible hearing damage, do not listen at high volume levels for long periods.

Additional safety and precautionary information can be found at the following link: www.mi.com/en/certification

Important Safety Information

Read all the safety information below before using your device:

• Using unauthorized cables, power adapters, or batteries may cause fire, explosion, or other risks.
• Use only authorized accessories that are compatible with your device.
• The operating temperature range for this device is 0°C to 40°C. Using this device in an environment outside this temperature range may damage the device.
• If your device has a built-in battery, do not attempt to replace the battery yourself to avoid damaging the battery or device.
• Charge this device only with the included or authorized cable and power adapter. Using other adapters may cause fire, electric shock, and damage to the device and adapter.
• After charging is complete, disconnect the adapter from both the device and the power outlet. Do not charge the device for more than 12 hours.
• The battery must be recycled or disposed of separately from household waste. Improper handling of the battery may cause fire or explosion. Dispose of or recycle the device, battery, and accessories in accordance with your local regulations.
• Do not disassemble, hit, crush, or burn the battery. If the battery appears deformed or damaged, stop using it immediately.
• Do not short-circuit the battery, as this may cause overheating, burns, or other injuries.
• Do not place the battery in a high-temperature environment. Overheating may cause an explosion.
• Do not disassemble, hit, or crush the battery, as this may lead to leakage, overheating, or explosion of the battery.
• Do not burn the battery, as this may cause fire or explosion.
• If the battery appears deformed or damaged, stop using it immediately.
• The user should not remove or modify the battery. Battery removal or repair must only be performed by an authorized service center of the manufacturer.
• Keep your device dry.
• Do not attempt to repair the device yourself. If any part of the device does not work properly, contact Xiaomi customer support or take your device to an authorized service center.
• Connect other devices according to their instructions for use. Do not connect incompatible devices to this device.
• For AC/DC adapters, the wall socket should be installed near the equipment and be easily accessible.

⚠Safety Measures

• Comply with all applicable laws and regulations restricting the use of mobile phones in specific situations and environments.
• Do not use your phone at gas stations or in any explosive atmosphere or potentially explosive environment, including fuel filling areas, below deck on boats, fuel or chemical transfer or storage facilities, or areas where the air may contain chemicals or particles such as grain, dust, or metal powders. Obey all posted signs to switch off wireless devices, such as your phone or other radio equipment. Switch off your mobile phone or wireless device when in a blasting area or in areas requiring "two-way radios" or "electronic devices" to avoid potential hazards.
• Do not use your phone in hospital operating rooms, emergency rooms, or intensive care units. Always comply with all rules and regulations of hospitals and health centers. If you have a medical device, please consult your doctor and the device manufacturer to determine if your phone may interfere with the device's operation. To avoid potential interference with pacemakers, always maintain a minimum distance of 15 cm between your mobile phone and the pacemaker. This can be done by using your phone on the ear opposite the pacemaker and by not carrying your phone in a chest pocket. To avoid interference with medical equipment, do not use your phone near hearing aids, cochlear implants, or other similar devices.
• Comply with all safety regulations on aircraft and switch off your phone when on board an aircraft when necessary.
• When driving, use your phone in accordance with relevant traffic laws and regulations.
• To avoid lightning strikes, do not use your phone outdoors during thunderstorms.
• Do not use your phone for calls while charging.
• Do not use your phone in high humidity areas, such as bathrooms. This may result in electric shock, injury, fire, and damage to the charger.

Declaration of Security

Please update your phone's operating system using the built-in software update feature or visit one of Xiaomi's authorized service centers. Updating software through other means may damage the device or lead to data loss, security issues, and other risks.

EU Regulations

Declaration of Conformity with RED

Xiaomi Communications Co., Ltd. declares that this GSM/GPRS/EDGE/UMTS/LTE/5G NR digital mobile phone with Bluetooth and Wi-Fi M2103K19G complies with the essential requirements and other relevant provisions of Directive 2014/53/EU on radio equipment. The full text of the EU declaration of conformity is available at the following internet address: www.mi.com/en/certification

RF Exposure Information (SAR)

This device complies with the Specific Absorption Rate (SAR) limits for general population/uncontrolled exposure (Localized 10-gram SAR for head and torso, limit: 2.0 W/kg), specified in Council Recommendation 1999/519/EC, ICNIRP Guidelines, and RED (Directive 2014/53/EC).

During SAR testing, this device was set to transmit at its highest certified power level in all tested frequency bands and was placed in positions simulating RF exposure during use against the head without separation and close to the body with 5 mm separation.

SAR compliance for body-worn operation is based on a separation distance of 5 mm between the device and the human body. This device must be carried at least 5 mm from the body to ensure that RF exposure levels are compliant with or lower than the reported level. When the device is attached close to the body, a belt clip or holster that does not contain metal components and allows a separation distance of at least 5 mm between the device and the body must be used. RF exposure compliance is not tested or certified with any metal-containing body-worn accessory, and the use of such accessories should be avoided.

Certification Information (Highest SAR Value)

SAR 10 g limit: 2.0 W/Kg,

SAR value: Head: 0.539 W/Kg, Body: 0.895 W/Kg (5 mm distance).

Legal Information

This device can be used in all EU member states.

Comply with national and local regulations when using the device.

This device is restricted to indoor use only when operating in the frequency range of 5150 to 5350 MHz in the following countries:

Restrictions in the 2.4 GHz band:

Norway: This subsection does not apply to the geographical area within a radius of 20 km from the center of Ny-Ålesund.

Receiver Category 2

Ensure that the power adapter used complies with the requirements of clause 6.4.5 in IEC/EN 62368-1 and has been tested and approved according to national or local standards.

Frequency Bands and Power

This mobile phone offers the following frequency bands only in EU areas and maximum radio frequency power:

• GSM 900: 35.5 dBm
• GSM 1800: 32.5 dBm
• WCDMA 900/2100: 25.7 dBm
• LTE band 1/3/7/8/20/28/38/40: 25.7 dBm
• 5G NR band n1/n3/n7/n8/n20/n28/n38/n40/n41: 26 dBm, 5G NR band n77/n78: 29 dBm
• Bluetooth: 20 dBm
• Wi-Fi 2.4 GHz band: 20 dBm
• Wi-Fi 5 GHz: 5150 to 5250MHz: 23 dBm, 5250 to 5350 MHz: 23 dBm, 5470 to 5725 MHz: 23 dBm, 5725 to 5850 MHz: 14 dBm
• NFC: 13.56 MHz < 42 dBuA/m at 10 m

FCC Regulations

This mobile phone complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This mobile phone has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

RF Exposure Information (SAR)

This device complies with government requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy. The exposure standard for wireless devices uses a unit of measurement known as the Specific Absorption Rate or SAR.

The SAR limit set by the FCC is 1.6 W/Kg. For body-worn operation, this device has been tested and meets FCC RF exposure guidelines for use with an accessory that contains no metal and positions the device a minimum of 1.0 cm from the body. RF exposure compliance for body-worn accessories containing metal has not been tested and certified, and the use of such accessories should be avoided. Any accessory used with this device for body-worn operation must keep the device at least 1.0 cm from the body.

FCC Note

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Shielded cables must be used with this device to ensure compliance with FCC Class B limits.

Electronic Label

This device has an electronic label for certification information. To access it, please go to Settings > About phone > Certification or open "Settings" and type "Certification" in the search bar.

Model: M2103K19G

2103 indicates that this product will be launched after March 2021.

Disclaimer

This quick start guide is published by Xiaomi or its local affiliated company. Improvements and changes to this guide, necessitated by typographical errors, inaccuracies in current information, or improvements to programs and/or equipment, may be made by Xiaomi at any time and without notice. Such changes will, however, be incorporated into new online editions of the quick start guide (please see details at www.mi.com/global/service/userguide). All illustrations are for illustrative purposes only and may not accurately depict the actual device.

This smartphone is designed with Corning® Gorilla® Glass 3.

Manufacturer Information

Manufacturer: Xiaomi Communications Co., Ltd.

Manufacturer's Postal Address: #019, 9th Floor, Building 6, 33 Xi'erqi Middle Road, Haidian District, Beijing, China, 100085

Brand: Redmi

Model: M2103K19G

© Xiaomi Inc. All rights reserved.