Zinus SmartBase® Euro Slats Mattress Foundation
Model: MESB-1 (Twin Size)
Before Installation
Prior to installing the kit, remove your mattress, bedding, and any other objects from the top of the platform.
Assembly Steps
-
Beginning at one corner, use the Allen wrench (C) to unscrew the 2 bolts (A) connected to the corner. Use the open wrench (D) to simultaneously hold the connected nut on the underside of the frame in place as you unscrew the bolt.
-
Place one corner bracket on top of the corner of the frame, and a second corner bracket on the bottom of the corner. Secure the brackets in place using the existing 2 bolts (A) and the Allen wrench (C) to tighten them. Use the open wrench (D) to hold the 2 nuts in place on the bottom of the bolts as you tighten them. Repeat steps 2 and 3 three more times on the remaining bed corners.
-
Above the side leg, loosen and remove the existing bolt using the Allen wrench (C). Insert the bolt into a washer (B) and use the Allen wrench (C) to tighten it through the same hole above the side leg. Repeat this step 3 more times for each side leg.
Components
[Bolt]
A x8pcs
[Washer]
B x4pcs
[Allen Wrench]
C x1pc
[Open Wrench]
D x1pc
