Installation Manual
Pull Out Sink Mixer
- For Model Code: 55705CH, 55705BK, 57305CH, 57305BK
Brand: Decaura®
Product Overview
An illustration shows the Decaura Pull Out Sink Mixer faucet, featuring a high-arc gooseneck spout, a pull-out spray head, and a single lever handle. The accompanying diagram displays the various components included in the package, such as the pull-out hose, spray head, inlet hoses, gravity ball, screws, nuts, washers, and the faucet body.
Please check over carefully the surface and accessories to avoid any damage and missing part.
Parts List
| No. | Description | Quantity |
|---|---|---|
| 1 | Pull Out Hose | x1 |
| 2 | Washer | x1 |
| 3 | Spray Head | x1 |
| 4 | Inlet Hose | x2 |
| 5 | Gravity Ball | x1 |
| 6 | Screw | x2 |
| 7 | Fixting Nut | x1 |
| 8 | Gasket | x1 |
| 9 | Washer | x1 |
| 10 | Quick Lock Connector | x1 |
| 11 | Washer | x1 |
| 12 | Body | x1 |
Instructions
- Working pressure: 0.05-1 Mpa, Working temperature: 0-55°C.
- Products are manufactured as per standard AS/NZS 3718:2005, as per Australian standard, and with WaterMark & WELS certificate as shown in the packing.
- All surfaces should be cleaned with water or mild liquid detergent. Do not use cream cleaner or citrus based or chemical cleaning products.
Warranty Terms
- All products are guaranteed as below:
- 5 years guarantee against main body, finishing and cartridge.
- 2 years guarantee on washers and O-rings.
Installation Steps
Step 1
Unscrew the fixing nut, stainless steel gasket and rubber washer from the kitchen tap.
Step 2
Cross all hoses through the countertop hole and hold the faucet body.
Diagrams illustrate the required countertop hole diameter, specified as 32mm (minimum) to 48mm (maximum), and the maximum countertop thickness, which is 45mm. A note emphasizes ensuring a rubber washer is present inside the tap bottom.
Step 3
Put the rubber washer, stainless steel gasket and fixing nut through the pull out hose, screw the fixing nut by hand and fasten it, then use a Phillips screwdriver to tighten the two screws until it is stable enough. Then connect the water inlet hoses to two copper ends in red and blue tightly.
A diagram shows the faucet body being mounted onto a countertop. It depicts the sequence of placing a rubber washer, stainless steel gasket, and fixing nut onto the pull-out hose before securing it to the faucet body. Water inlet hoses are shown connecting to the faucet.
Step 4
Insert the pull out hose end into the plastic connector. Make sure the hose is properly engaged and secured in the plastic connector. Fix the gravity ball where the label specified, tightly fasten the tow screws. Then pull out the shower head and release it for several times to check if it is working smoothly. Connect the two water inlet hoses to the angle valve as per red/blue mark.
This diagram illustrates the installation of the pull-out hose and the gravity ball. It indicates the placement point for the weight (gravity ball) on the pull-out hose. The diagram also shows the connection of the pull-out hose to a plastic connector and the water inlet hoses to angle valves, noting the red and blue color coding for hot and cold water connections.
