Square Rain Shower Set
Model Codes: 8557, 8557-2, 8557-3, 8557-4 (In different shower heads only)
Instructions
- Working pressure: 0.05-1 Mpa
- Working temperature: 0-55°C
- Products are manufactured as per standard AS/NZS 3662:2005.
- All surfaces should be cleaned with water or mild liquid detergent. Do not use cream cleaner or citrus based or chemical cleaning products.
Warranty Terms
- 5 years guarantee against main body, finishing and Cartridge.
- 2 years guarantee on washers and O-rings.
Parts List
| No. | Description | Quantity |
|---|---|---|
| 1 | Mounting Nut | x 1 |
| 2 | Connector | x 1 |
| 3 | Nether Pipe Holder | x 1 |
| 4 | Nether Pipe | x 1 |
| 5 | Sliding Bracket | x 1 |
| 6 | Upper Pipe (with main body) | x 1 |
| 7 | Shower Head | x 1 |
| 8 | Hand Shower | x 1 |
| 9 | Shower Hose | x 1 |
| 10 | Plastic Anchor | x 1 |
| 11 | Long Screw | x 1 |
| 12 | Allen Key | x 2 |
| 13 | Teflon Tape | x 1 |
| 14 | Grease Oil Pack | x 1 |
Spare Parts:
- 15: M5 Grab Screws x 4
- 16: Spare Shower Hose Rubber Washer x 1
- 17: Spare O-Rings For Upper Pipe x 3
Installation Steps
-
Step 1
Find a proper position and drill one 6 mm hole for mounting nut. Water supply outlet G 1/2". The distance for the upper pipe is 350-550 mm.
-
Step 2
Should wrap enough Teflon tape [13] over the water supply outlet. Screw the connector [2] to water supply outlet and tighten firmly by spanner. Put plastic anchor [10] into drilled hole and fix the mounting nut [1] by long screw [11] firmly.
-
Step 3
Smear the grease oil [14] on the connector O-rings. Don't wrap Teflon tape over the O-rings. To avoid connector O-rings scratched by screw tip and causing water leakage, the screws must be located long enough before plug the main body onto the connector. Unscrew the grab screws located on the bottom of nether pipe. Then plug the upper pipe [6] to nether pipe [4] together and tighten firmly by 2 grab screws.
-
Step 4
Unscrew the nut [1] and allen key [12] to adjust the holder to proper position and fix it firmly by a big allen key. Gently plug the holder onto the mounting nut and tighten it by 2 bottom grab screws.
-
Step 5
Make sure washers and flow restrictor is shown inside shower hose. Make sure washer and flow restrictor is shown inside shower hose. Screw shower hose to arm.
-
Step 6
Make sure washer as shown inside shower hose. Please note that the conical nut should be connected to handheld shower, the hex nut should be connected to shower rail.
