LampsModern Installation Instructions
Model: CL0193
Product: Simple Round Hallway Semi Flush LED Ceiling Lights
A visual of the LampsModern Simple Round Hallway Semi Flush LED Ceiling Light, featuring a grey drum-shaped shade with a white LED diffuser and a natural wood accent at the top, mounted flush to the ceiling.
Installation Steps
Step 1: Turn Off Power
Locate the circuit breaker or fuse box that controls the power to the installation area. Switch off the power supply to avoid any electrical hazards during the installation process.
Illustration: A hand is shown turning a switch on a terminal block from the 'OFF' position to the 'ON' position.
Step 2: Mount Bracket
Hold the included mounting bracket against the wall at the desired installation height. Use a pencil to mark the positions of the screw holes on the wall. Ensure that the bracket is level.
Using a drill, create holes in the marked positions on the wall. Insert included anchors into the drilled holes to provide secure attachment points for the screws.
Illustration: Shows tools (drill, hammer) for wall mounting, followed by a bracket being attached to the wall with screws and anchors.
Step 3: Install Lampshade
Install lampshades from top to bottom.
Illustration: Shows wires hanging from the ceiling, with a mounting plate being secured to the ceiling using screws.
Step 4: Connect Wires
Connect the lamp wires to the reserved wires using insulation tape.
Illustration: Shows electrical wires (blue, green/yellow, brown) being connected and secured with insulation tape.
Step 5: Secure Lamp
Screw b through a and into the expansion screw. Tighten the nut to fix the wall lamp.
Illustration: Shows the lamp body being attached to the mounting bracket with screws.
Lamp Instructions & Safety
Maintenance & Precautions
| Maintenance | Precautions |
|---|---|
| 1. Voltage: 220–240V | Keep the lighting away from acidic chemical solvents to avoid damage. |
| 2. Please wear gloves when install. | |
| 3. Don't install it on the moist ceiling. | |
| 4. Turn off the power before cleaning out. | |
| 5. Please wash with the sanitizer without corrosivity. |
Tip
Please follow the instructions then install the parts in the correct order.
Safety Symbols Key:
- [electrical hazard warning]
- [wear gloves]
- [do not install on moist surface]
- [turn off power before cleaning]
- [use non-corrosive cleaner]
- [general caution]
- [ground connection]
- [disposal warning]
- [do not use hammer/chisel]
- [do not use in explosive atmosphere]
- [do not operate if damaged]
- [recyclable]
