WALL MOUNT INSTALLATION
INSTALLING / REMOVING THE BASE STAND
WARNING: The LED Display is very fragile, and must be protected at all times when removing the base Stand.
Be sure that no hard or sharp object or anything that could scratch or damage the LED display comes into contact with it. Do NOT exert pressure on the front of the unit at any time because the screen could crack.
- Disconnect all cables or cords connected to the unit.
- Lay the unit down on a flat surface with the back side facing up. Please make sure to place a soft cushioned material (such as a pillow or thick piece of foam) beneath the screen.
- To remove the base stand, loosen screws off the holes then pull downwards to release the base stand.
Never place a television set in an unstable location. A television set may fall, causing serious personal injury or death. Many injuries, particularly to children, can be avoided by taking simple precautions such as:
- Using cabinets or stands recommended by the manufacturer of the television set.
- Only using furniture that can safely support the television set.
- Ensuring the television set is not overhanging the edge of the supporting furniture.
- Not placing the television set on tall furniture (for example, cupboards or bookcases) without anchoring both the furniture and the television set to a suitable support.
- Not placing the television set on cloth or other materials that may be located between the television set and supporting furniture.
- Educating children about the dangers of climbing on furniture to reach the television set or its controls.
If the existing television set is going to be retained and relocated, the same considerations as above should be applied.
| Pedestal Screws | Quantity |
|---|---|
| BM4x20mm | 6pcs |
The diagram shows pedestal screws and their quantity. It also illustrates how to attach the stand to the TV using these screws.
MOUNTING ON THE WALL
This unit is VESA-compliant, and is designed to be wall-mounted with a VESA-compliant 11.8"x7.9" (300mm x 200mm) mounting kit designed for flat-panel TVs (not supplied). Length of screw should not exceed 10mm.
NOTE: Remove the base stand before mounting the unit on the wall.
The diagram shows the back of a television with four mounting holes. The dimensions of the VESA mounting pattern are indicated as 11.8 inches by 7.9 inches. The mounting holes are labeled as size M6x4 screw.
