Instruction Manual

Thank You

Thank you for purchasing this product. To achieve the perfect hidden-line effect, we use severely thin aviation-grade wire with high tension and pressure tolerance. However, due to its thin nature, be careful not to cut through it as it might be susceptible to shearing during installation. Always be careful not to press brick pieces down on the wire.

Let's Get Started

If you face any challenges, please feel free to reach out via support@gameofbricks.eu. Please note that we offer 2 years of free light kit maintenance.

Step 1 (Bag 1)

This step involves installing the first set of lights into the front section of the Dom's Dodge Charger model, focusing on headlights and grille details.

• Open Bag 1, which contains small LED strips and connecting wires.
• Begin by carefully placing LED strips and routing wires around the front bumper, grille, and headlight assemblies.
• Route the thin wires through designated channels in the model's chassis, ensuring they are not pinched or stressed.
• Connect the LED modules to the wires, paying attention to the correct orientation for each light component.
• Gently press the LED components into their intended positions within the front bumper and headlight housings.
• Continue routing wires along the underside and sides of the front chassis, preparing for further connections.
• Ensure all wires are neatly tucked and secured in the front section.

Step 2 (Bag 2)

This step focuses on installing lights in the rear section of the Dodge Charger model, including taillights and license plate illumination.

• Open Bag 2, which contains components for the rear lighting.
• Identify the rear section of the car, specifically the area around the license plate and taillights.
• Place LED strips into the designated slots for the taillights and any other rear lighting elements.
• Connect the wires to the LED strips and route them carefully through the rear chassis, ensuring they are hidden and organized.
• Ensure the LED modules are properly seated in their locations within the rear bumper assembly.

Step 3 (Bag 3)

This step covers the installation of lights in the engine bay and potentially other interior areas, culminating in the power connection.

• Open Bag 3, which contains components for the engine bay and other detailed areas.
• Install LED strips and components within the engine bay area to highlight the engine details.
• Carefully route wires from the engine bay and other interior locations through the model's internal structure, following provided paths.
• Connect the wires to various points on the car's chassis, ensuring a clean and organized layout for all wiring.
• Connect the main power cable (likely a USB connector) to the assembled light kit, routing it towards the battery box location.
• Make final connections to the battery box or power source, ensuring all lights are properly integrated and secured.
• Verify all installed lights are functioning correctly after connecting to power.

Final Connection

Connect the light kit to the battery box, and the installation will be complete. If you wish to use another power source, please ensure the maximum voltage is 6V.